Viewing all customer Discussions for:

10-324 24" Shower Sweep With Drip Rail

Hi, I have attached two photos of my door sweep. It would be great if you can recommend a replacement part. Thanks!

Looking for new shower door sweep gasket - Which one that you sell would be the closest? It has a half moon top Thank you in advance

Assuming this product will work as a replacement for the plastic shower sweep currently installed? Can holes be drilled to match existing screw placement on the door. Picture attached Thank you.

Hi! My shower door bottom sweep is cracked. I need a replacement, please see the pictures attached if you have any part I can replace? Thanks! Sam

Aqua Glass corner shower 1. Rubber shower sweep 2. Aluminum attachment strip, 21.5", if possible. Thank you.

I have a shower door sweep that is just wedged into the bottom of the door frame(friction fit) do you have anything in your inventory to replace it ?

My shower sweep needs to be replaced. It's 23" long and the drill hole on the inner part of the seek is 3" from the end while the drill hole on the other side is 3 1/4" from the end. Can these be custom made by your company. Thanks Gary

Hi This might sound like a ridiculous question, but does the shower drip go on the inside or outside of the shower? Or does it matter? Thanks

The sweep is about 22 inches wide. It appears to be a makeshift deal.. My question is : will your 10-325 work for this situation

I noticed on the 10-324 shower door sweep you recommend a screw size. Do you also recommend a double side bonding tape that can be used instead? If so do you have a part numbe? Thanks David

I've attempted to replace the sweep in my shower door. I used a 1-inch clear vinyl. The problem is that I have a large gap beneath the drip pan that remains even with the 1-inch sweep. Do you have a sweep that is much longer than a 1-inch? I've attached a photo of the sweep and of the remaining gap. ... (cont.)

Please see picture I uploaded here. I am looking to replace this chrome drip with rubber sweep. I've pulled out the drip since taking this picture. Do you make a specific part/drip that I can re-lodge back up into the existing door frame? And, if so, how do I do that? There are no screws that hold i ... (cont.)

I need just the seal that slides in and out. The actual tub part of the shower is an Aqua Glass. The metal cover that the seal slides into is 20 1/4" and the door is 20". Thanks

I need to replace a 24" that has fallen off my shower door on which also the vinyl has rotted away. There do not appear to be any screw holes in the bottom of the shower door. Will I create these by driving a screw into the door? Or if my door simply wasn't meant to have screws used...is using two s ... (cont.)

How many screws are required on yours?

I have a Shower Sweep w/drip rail that has came off of the shower door - probably the same item pictured in the 24" shower sweep w/drip rail image. What size screws do I need to reattach the sweep? All I will need are the screws, correct? Thanks!

This is a 29" swinging glass door. Any clue on what I need to replace this strip with? Do I need to replace the whole bottom part after removing two screws?

Hello, I need to reseal my shower door, both along the bottom and the side where the door meets the frame. Hopefully the attached pics show enough. The bottom frame does not have any visible screws. The glass is 3/16" and the frame is 1/2". The gap between the glass and the frame at the side is 3 ... (cont.)

Looks to be longer than 1inch to stop water from coming out. Please advise! Thank you for your expertise! LJ

Hi could u help me find the correct shower door sweep When I went to clean it I pulled the plastic part out and it just kinda fell apart Went to Lowes they said I should buy new door My husband isn't very handy...but I still love him So I usually end up doing these things Any help would be gre ... (cont.)