Viewing all customer Discussions for:

10-324 24" Shower Sweep With Drip Rail

How far from each end of the sweep are the screw holes?

Gasket is missing. Do you have one? Looks like it screws behind the water shield. Should I just put a whole new replacement shield with gasket?

The rail is not as wide as the door bottom, and I'd like to know how to position the rail (left to right) on the door? Also, do you have the replacement screw? There are three screws, pan head, phillips, sheet metal threading (pointed), look like galvanized steel. Length of screw is 5/16" total, ... (cont.)

Long side is 5/8". Side fitting into channel is 3/16" - see pic.

Hi I was wondering if I can get a 10-324 in brass color But 30" long

I have a problem with my sweep. On the side that is hinged, I still get a water leak. I have something similar to 10-324 in design. Should I replace the whole thing or is there some other solution? Thank you.

I have a stall shower with a 24" door that needs a new drip edge. The current drip edge measures just under 23" - shouldn't I be able to find a drip edge that's an exact match for the one I'm replacing? If I use your 10-324, I believe I'll have to cut it down on both ends, and also drill new holes ... (cont.)

Need to replace worn out door sweep of my 15 yr old swinging shower door.

Hi - I am going to be installing your 10-324 and my question is... If the sweep gasket material is too "tall" to shut the shower door easily - can it be cut (horizontal cut the width of the shower door) and what's the best rule of thumb for keeping the water IN? Thanks!

What size screw do I need to fasten this shower sweep?

As you can see in the picture, my shower door seems to be missing a piece at the bottom. There is therefore a gap between my shower door and the bottom of the shower and water leaks out. What do I need to buy to fix this?

I have a Keystone Shower door B5864. I need new sweeps for 2 doors. The piece I have is 19 inches in length but is a bit shorter than the door opening. I am attaching some pictures with tape measure. It looks like a T. The part that slides into the door seems to be about 3/8 and the part that hang ... (cont.)

Hi, I need to replace my drip rail. Its 22" with elongated holes at 4" and 19". I was wondering which drip rail should I order? Thanks, Vikas

I need to replace my framed shower sweep with drain rail. Could you please recommend what I should get from you based on the photos attached. I don't know who the manufacturer was. The shower was installed in 1986. Thanks.

Hi, I need to replace my shower door sweep, and your 10-324 fits most of the dimension except the width, cna it be easily cut by hacksaw? Thanks Albert

Can I purchase a brass colored door sweep? Not chrome. Thanks

Please refer to the attached picture. The shower door is

On your 24" drip rail, how far apart are the screw holes?

I recently ordered and received a Round Top Sweep (#10-320) for my hinged shower door. The round top is too large to fit the door track. Does SWISCO sell a similar sweep with a smaller diameter round top? If not, can you offer any suggestions? Thanks... David Rockwall, TX

hi I'm looking for a shower door sweep similar to this one: Shower Door Round Top Sweep Product Code: 10-320 But the one I need is 1/2 round top See pic Thank you