Viewing all customer Discussions for:

26-425 Pivot Pin and Housing

I am repairing the bottom of the bottom sash and need to know if 26-425 will work. Picture attached Thank you Vince

I'm looking for these for quite a few double hung windows. I cannot remember the make of the windows. Any help would be appreciated.

No markings

The 2 the left seem the same( except taken apart from the housing), I need qty of 4. 26-425 looks pretty close. I also need 3 of the far right, could be part of 26-426, but I was unable to get the housing out. the cast pivot cane out with removing 1 screw. any help would be appreciated. I know they ... (cont.)

Hi, I'm looking for a pivot bar: 20+ year old vinyl double-hung (generic) windows, no markings pivot bar includes nylon housing; no bottom screw - have to take of side piece (2 screws/stile). Fairly close to 26-425 (no wings) - is it likely that that one would work? Thanks, David ... (cont.)

Do you have anything like this? I couldn't find it on your website. I need 2 pcs. Thanks in advance!

Need help locating pivot bar. Can you help me please

I have been unable to find the manufacturer listed anywhere on the window. I need to pivot pins for the windows. I hope you can help me identify the manufacturer and parts I need.

I believe it is a 200 series tilt wash but I cant find the part. The sash ( upper and lower) hinge on this part. need 2 but figure I need a few for stock

Enclosed are photos of a double hung pin set that rests in a plastic holster. Manufacturer is unknown. The pins are broken off and they do not look like they are handed. They are about 3 1/2" long plus the length of the pins. Can you recognize these or help

Please let me know what replacement parts would I need for the housing and pivot bar. Need housing and pivot bar. Thanks for your help.

Looks like there's a U-shaped pivot bar inside as well as something on the bottom

Windows with no markings on metal under glass. Marking on one part of bottom sash's spring mechanism read "24B BS1". Marking on a sticker on the side of the sash read "14355 B08 DH72 GLASS #1: SSCLIG14 28 1/8 x 25 15/16".

These windows are very generic and hard to find numbers on. That is why I sent a few that have numbers. There are no numbers on the metal under the glass like most windows have for identification. The other pics show the pivot hardware. One shows what it looks like in the window. The others are t ... (cont.)

It has 6216 in the casting

Looking for this part....can you help

Old vinyl double tilt-sash window. Only marking is stamped into the metal balance channel shown below. Two imprints read 26B cBSI Pivots are broken off where they extend from the bottom channel of the sash. They normally slip into the bottom shoe, allowing the sash to tilt back into place. Th ... (cont.)

6225 on it I previously sent 3 photos without this seat, thought it may help

Repairing some windows at our Legion Post and have had great luck finding parts at Swisco. Several of our windows have pivot bars missing or bent. Ordered SWISCO Part Number: 26-040, 3inch pivot bar. Works great, however have sashes where the pivot bar holder is broken (bottom of window on left ... (cont.)

This is a lower sash pin.