Viewing all customer Discussions for:

38-169 Casement Window Locking Handle

I am looking for the plastic wedge which is 1-5/8" x 1/2". Pins are offset 3/16" and are 1-3/16" apart center to center. The distance from the edge of the lock mount to the end of the arm on the wedge is 5/8"

Need 3 handles will check for right or left.

This is a residential window handle for an older (about mid-late 80's), presumably high-end, aluminum window frame. The handle is about 3.5" in length. Please let me know if you have any additional questions. Regards, --> Andrew

The handle on the window came off. I think it broke off or maybe just came apart. Anyway, I was not able to re-attach it to the window. Once the window is open it is difficult to close. I am not sure if I need just a new handle, the handle and the attachment to the window, or a completely new wi ... (cont.)

Our window company is 2 months out to measure! We will replace the window but the latch is broken. It measures 1.5 inches between screws. Do you have anything that would work? I would like to order the part from you.

1 1/2 spacing in screw holes

How does this handle lock?

I need a replacement locking handle with base for a Milgard casement windows vintage 1989? Handle broke off its base. ID on aluminum between panes Milgard MG-1 A.L.L. CBA.

These are old aluminum windows. I need hardware for those. If possible. Handle and a hinge for the Same. Thanks.

I'm looking for 38-168 in aluminum. The ones in working on do have a slight offset to the keeper side on the frame. Anything similar in aluminum?

Good morning, Here are photos of a working latch and a broken one. No identifying label on the windows, which are likely to be old. I am hoping you either have identical latches or substitutes that will work. Thank you. Aloha, Louise

I need 2 of the OPPOSITE HAND handles than those in the pictures. The base looks very much like 38-064. HOWEVER, notice the strike in the pictures. The picture does not seem to match the strikes that match up with 38-064. Would you please give me a part number for the OPPOSITE HAND of the the ... (cont.)