Viewing all customer Discussions for:

81-183 Stainless Steel Tandem Roller, 1-1/2" Concave

Need new tandem 1 3/4 rollers and guide

"Disco 2007" is stamped on the roller housing. Wheel assembly is spring loaded. I have ordered this roller elsewhere, but it was not stainless and did not have the flange that extends from one end of the roller housing that is used to fasten the roller into the bottom of the panel. ... (cont.)

Need to replace tandem rollers on YKK sliding doors. Door system is YSD600. In manual for YSD600 door system, YKK part number for tandem roller is E1-1620. Do you have an equal?

Can wheels be adjusted from side of door, since I cannot access one end of each leaf with a total of four leafs. This will make a big difference on my purchase since they won't work in the application they are needed for.

LOOKING FOR THIS TYPE OF PATIO DOOR ROLLER

Looking for rollers for patio doors at the condo building I work at.

Stainless Steel Sliding Door Rollers Kawneer 990 590-411

I need to purchase two sets of this roller. they're on commercisal doors installed 1993 government building. no name plates can be found. as you can see they have two screw hols not 1 like I found on your site. Any help would be appreciated. Project Manager Wayne

Hi, Are these 81-183's the heaviest duty SS rollers you carry? What is their capacity? And what is the capacity and differences to the 81-163 and 81-173? Thanks, Matt

Hi there, I am a contractor going to do a New house build for my family. Our property is on the water and the township has some strenuous requirements for the windows and doors Making them quite expensive to factory order. I am considering ( I am an architectural woodworker) fabricating the windows ... (cont.)

Unfortunately after receiving the rollers and attempting to install they do not fit. The new rollers are missing these little

my name is Jared I was referred to you by Himmels Hardware. Attached are pics of sliding patio doors and rollers at one our properties the Civic Lofts. I didn't find any manufacturer stickers, labels, or stamps on the doors, frames, or rollers. The door is 94

I have a Kawneer door that on side is down. There are two adjustment screws, but they don't seem to do anything. How are they supposed to work?