Viewing all customer Discussions for:

32-003 Rear Drawer Track Socket, 1-1/4" X 3/8"

Trying to fix a kitchen sliding drawer

Please ignore the duct tape I'm not able to get the dimensions at this time. I thought you might have some thing that could work.

The pic i attached is of the side that is not broken. I just need the plastic bracket that holds the rail in place.

Looking for replacement bracket for kitchen cabinet pat #4930739 ordered 32-119 and does not work. It is to narrow catches on the bump edge.

This plastic socket broke for an old built-in in our basement. It was installed by a previous owner, possibly original in 1966 or later. Trying to identify an equivalent replacement.

I am wondering which rear bracket would be better for my 1960 kitchen drawer with roller track. 32-012 or 32-001, the track measures 1 inch. See attached photo. Also what size screws would be needed it looks like some were stapled in. Thank you.

Rearback plate 2.1/2 x 1.5/8

Trying to locate a rear drawer guide bracket.

Folks, Here's picture of the rear mount track support that I need. The track is 1 1/8" at the bump close to the end of the track. It is barely inside the holder. I've looked at 32-028, 32-003, and others but don't know which would work. The track was installed about 40 years ago. Your help will b ... (cont.)

This is a 39 year-old rear mount for a drawer slide. It's in a kitchen cabinet and is broken. I can't find this part anywhere. Any help would be appreciated.

Home was built in 1987. Need some rear brackets for kitchen cabinet drawers. Best images I could get as they are underneath the oven.

See photo - this piece broke (the plastic cracked and isn't holding the channel/slide). It is a Delta Series 50 - I don't see this replacement on your website. Please advise if it is available.

I'm looking for help in finding this piece to fix my other drawer. Dimension width was about 1 inch inside plastic piece. I don't have any part information other than the table is a broyhill that we purchased new 20 years ago.

a socket for a very old drawer slide. There are no numbers or other makings on any component of the drawer slide.

The drawer slider inserts into the socket and the socket can slide left to right a little inside the bracket. The slide that goes into the socket is 1 3/8" tall. I ordered part 32-003 and the slider is too big for the socket.

THIS PART IS TO MY DRAWER IN MY KITCHEN. THE PART HAS BROKEN OFF AND I NEED A REPLACEMENT TO FIX IT. WILLING TO PAY FOR. THANKS.CYNTHIA

1 7/8" length with 3/4" between prongs 3/4" width plastic

Can you recommend the part(socket) to replace the broken piece illustrated in the attached photos.

I have some unique looking hardware for the drawer of kitchen cabinet. It does not attach to side wall of cabinet. It is just attached to front of drawer frame (opening) and to back wall of cabinet. Do you sell anything like this.Thank youMarie

Hello, I'm hoping you can help me with this. I can not find this part anywhere.Thank you,Judi