Viewing all customer Discussions for:

32-012 Rear Drawer Track Socket Pair

The actual opening is about 3/8 by 1 inch.

The description of the brackets state for a pair, is it per rail or per drawer ( both sides )?

The drawer slide (image drawerslide4) keeps coming off the plastic rear drawer socket. I believe I used part #32-003 or 32-005. How can I keep the drawer slide. Is there anything deeper to secure it better? What else can I do? Would it be better to just get new hardware? Thank you for any ideas. The ... (cont.)

This is the picture of the track. I need the back guide. It has to be at least one inch that the track would fit into. Thank you so much for your help.

I am looking to replace these for my kitchen drawer. I've tried local hardware stores but no one carries them.

Markings - mepla, high point, USA. 600.010.02.00 Base- 1 inch wide, 2 1/2 inches long, 1/8 thick Socket- 2 1/4 inches long, inside socket 1 1/8 inches, outside 7/8 inches Arm- 21 1/2 inches overall, 1 inch wide, front lip 1/8 inch, bottom of lip to base 3/4 inches

One side of our top cabinet drawer has broke. Need to replace. I order 32-012 but it is 3/8" to 1/2" too long. Also, the back side of the broken piece looks to be glued to cabinet back, not screwed in. Any ideas how to take the old piece off when replacing with new?

Please help can't find anywhere

I need a rear replacement part for the right side of my 1987 marillat cabinet. These numbers are on the inside of the part. 471037

need rear drawer track socket for Hettich 602 track left side

I cannot find the correct bracket for my rental property. The only markings on the bracket are LDP-3. The height of the bracket for the slide is just one 1 inch.

I need to find a replacement for this guide for my kitchen drawer

please HELP I need 6 sets of tracks.all my tacks are old and need to be replaced the measurements are 23 inches in length. thank you

The broken bracket in the back of the cabinet appears to be glued. Are the replacement brackets to be glued or screwed. Thanks.

Tried gluing this broken socket a couple of times, but it didn't hold for long. Cabinetry is 23 yrs old and I have searched high and low for a matching socket to no avail. The opening for the drawer slide is 1" high x .4" wide. Left hand side.

I purchased a rear drawer track socket pair-part number 32-012 for my Merillat cabinet. This is to replace my old style plastic adapter that broke. Could you please guide me as to the best way to mount the new adapter? The back board is not too thick, looks like particle board. Do I place the ne ... (cont.)

Need back mounting brackets for our kitchen drawers. They are old. Ones we have are plastic, brown color. They do not screw into the back they have interlocking studs that go into pre drill holes to stay in place. They are about 1 3/4 wide. The part that the slider slide into is about 1 7/8 long. ... (cont.)

The drawer slide won't stay in because the socket is broken

Trying to find a replacement for the right side.

I am looking to replace a broken bracket on my merit att cabinet pull-out drawer. The part has number 471037 on it. I've seen information that part# 32-012 is the correct replacement part. It also mentions that this has been a problem for years What should I do?