Viewing all customer Discussions for:

32-012 Rear Drawer Track Socket Pair

Looking for a right rear back bracket for a drawer/shelf slider. This is the piece that presses into place to accept the right slider of the drawer. - No part number or brand on part - Plastic/Nylon - Presses into existing holes in the back of the cabinet

As seen in pictures maily need the end piece that holds the rails in olace if possible or if part of a kit. Probably could use half a dozen if could get. Please advise part number and or how to order. Thank you very much

Hello, this is the left side of the part I need. I need the same bracket or one that will work for the right.

We have a bracket that slides into the metal track and is pushed into a piece at the back wall of the cabinet. The piece that the metal bar slides into cracked. How do we remove the piece that is at the back of the cabinet. ours are very very tightly glued to the back wall. The cabinets we have ... (cont.)

Looks like Houck 051 on this plastic piece

I have Unigrass 6600 drawer slides on drawers of 18 year old kitchen cabinets. The bracket attached to the rear of the cabinet has cracked. What replacement part would work for this? I have a feeling there will be more. Thanks!

I am looking for this part. Back of drawer. This connects to a metal bar. Holds the drawer slider. The one picture shows how it looks assembled. It has a screw in the middle. This is not part of the part. It was a fix for the other one that broke also Thank you

This part is located at the end of the drawer rail. Haas cabinet brand about 30 years old. Looking for a replacement part. I need 4-6.

Need 2 sets of rear track plastic holders. That is 2 right and 2 left rear holders. Thanks.

The bracket on back wall of upper slide broke. Not sure how to get it out. Also need several new ones since we have had this happen before. The Item Code from Superior Cabinet and Window in Park Forest from a 2010 invoice was MDSL24. Any info would be appreciated.

I need the part shown in the attached photos. It is definitely a SWISCO part! It snaps into a plastic base, that is glued to the back of a kitchen cabinet. It supports the end of the right-side slide rail for a sliding drawer. Can you help? If you need better pictures, I will get them for you. ... (cont.)

I have these plastic parts at the end of my metal drawer rails for a kitchen drawer. One of them has broken and I need to replace it, but I can't seem to find something that will work. Any help would be much appreciated.

These side mount slide bases are not mounted with screws but instead pushed into predrilled holes via peg on back of mount. The sliding portion allows drawer positioning flexibility. Looking for source since there are about 24 drawers in this kitchen and potential drawer slide base mount failure pot ... (cont.)

I am looking for a match for Kitchen Kompact Product ID: 982279 I believe. Can't find a schematic anywhere for it. Max length of bracket from backplate - 2 1/4", and track opening needs to be 1" Your 32-012 might work?

Tried numerous other ones and the bracket keeps the drawer from closing the whole way.

I need something that will work to replace this bracket that is broke. The issue is, this is mounted on a strip of wood that is only about an inch wide. See images.

Hello, I'm looking for the attached track rear end sliding socket that broke on the other side. I need the one that goes on the back panel.

Looking for a backplate with the following measurements: 2 1/2 X 2 1/2 with a 1 1/4 rail opening. Rated for #100. Can't seem to find them.

Here is what I need

Broken