Viewing all customer Discussions for:

32-053 Drawer Track Kit

Haas cabinets installed in the 70s Broken bread drawer center rail. Replace center track rail or install new ones with minor modifications. Stamped markings KNAPE VOGT no.117 Stamped to the side large (H) Length 22.75"

Your website says only right tracks one is available now can I replace the whole system and put right tracks one in place of my right tracks too or where can I get the right tracks to

American wood Mark drawer glide bracket

My dresser drawer glides, as you can see in pictures, are about 40 plus years old. The ball bearings in them are starting to pop out and drawers won't stay on the glides. This is Thomasville furniture. Any thought on what type of glides I can use as a replacement? I am not finding the same type of ... (cont.)

Customer is looking to purchase a Complete Drawer Track Set that he purchased a few years ago that is featured in this video. The Product Code is mentioned as being 32-063 however when searched, it no longer pulls up any parts. Was this kit discontinued? If so, are we able to put together an order ... (cont.)

Drawers pull out and will not stop. Plastic part on back of drawer does not look broken. What is the part I need to stop the drawer from pulling out for wood center drawer glide. Thank you

Looking for a drawer socket with 'N A 10' on it and a wheel, do you have any of these?

I have a Standley dresser and some of the drawer glides are broken. Kenyon rite trak11. I'm not sure about the 11 Pat. Pending 8485 120 6116706 W6

Hi -- I have a ~20 year old dresser and the drawers fall down when you pull them out. The plastic pieces seem beat up/broken and the tracks on the bottom of the drawers are also bent/blown out. We bought the dresser used from someone so we don't have a clue whether this has always been an issue or s ... (cont.)

There is no current hardware on this old tv armoire. The drawers fall out at about 1'. Do you have a part that would work on these old wooden drawers to allow them to be fully opened without falling? The measurements are:on drawer: 2" across where metal piece is attached groove is 11/16" w ... (cont.)

I need to replace drawer traction kit brackets and rod. Which replacements do you recommend pic above is what I currently have they are broken

im looking for both the rail (pictured) and the mating rail that's installed on the bottom of the drawer

17 3/4" draw slide wood 3 screws 1/2" height 1" width to fit into underside draw tract exactly (Is it possible to change to a metal glide?)

The little mental internal Gabon the drawer glide has broken off.

Hello hoping you can help me save these dressers that we bought for our daughter some years ago at Sam's Club they are of a good quality but like everything things break all the metal tracks are there except for one and it measures 14 to 15 in Long there's a track that goes along the bottom side of ... (cont.)

Good morning, I see the replacement rear drawer guide, but what do you suggest for the front - or for a rail to keep it lined up nicely? Thanks

I have an old Thomasville dresser chest of drawers. All of the slides are broken. Wondering if you sell anything I could use to replace these? The bottom piece measures 16 1/2 inches

Hello I would like to replace my drawer slider with metal slider is this possible?

I'm looking for a drawer slide, bottom, center mount. No wheels or balls. one I need a 23" and the other I need a 20 1/2" Can you help me? Steve L

My kitchen cabinets were built in 1980 and are custom plywood. The drawers are heavy by themselves. They all have a monorail drawer slide. What is the weight rating for your monorail slides? I would rather replace them with a ball-bearing center slide, but it might be easier to just replace the mon ... (cont.)