Viewing all customer Discussions for:

32-053 Drawer Track Kit

Do you happen to know if you guys carry this piece I know the photos aren't the best, but I need two of them. I cannot find them anywhere :(Outlined the only single marking on it which is a "2" let me know if you need measurements I hope this does it lolThank you!

The 3 parts make up a Center drawer glide for ChildCraft dresser. The glide is 15-1/2" long.

Hello, the white part pictured is the part I need. I need this part for three different drawers, all with the same measurements. This is a old dresser that we refurbished. I see no marking, names or numbers.

Would this system work to replace the old metal slide and wooden track system shown in the attached photos? The width of the drawer is about 24" and 15" depth. I wasn't sure if that would be too big of a drawer for this type of system.

need replacement for drawer replacement. This is an 11 1/2 by 2 1/2.

Do you have this type of slide pictured below? It is exactly 15-1/2" long.

I have a 44 year old Thomasville bedroom set. I need to replace a few of the tracks for drawers. I have 2 16 inch ones that need replace and 2 14 inch ones that need replacing.

Thank you

Looking for rollers for top center drawer slide.Appreciate advice.

Do you have a bottom dresser drawer center support channel 14-3/4" similar to attached photo?

Looking for an old drawer slide bracket or the whole assembly. The plastic bracket that holds the end of the slide is broken.

0ne of the drawer guide braces broke. here is a picture. Kenlin Rite-Trakll how do I go about getting a couple replacement braces.

Hello I am trying to fix my son's dresser drawers they keep getting off the track and you can't close the drawer correctly.

What is this part that goes on the drawer? The slides r wooden. But these are metal and they slide on the wooden peice. I need help identifying so I can order more. Thank you!

I am looking for 14" metal slide for an old dresser drawer. The metal track died of metal fatigue. The wooden track is intact and attached to the drawer base below. The width of the track is 1 1/4" wide and technically 13 3/4" long. However I am sure a 14" is appropriate. If you can help, plea ... (cont.)

Hi there. Updating a very well built mid century desk and hope to replace all the ball bearing slides. Photos are os the smaller drawers just to see if you can help. The larger ones (not shown) all say Grant. I know they are from the 70's-80's era. The desk was built around only having limi ... (cont.)

Unable to find plastic guides on cabinet where plastic drawer goes. Unfortunately I am unable to figure out how to attach the photos I took because I can't find this message when I return from photos

Please review the image of the part that I need a replacement for.

Hi, I have been researching how to replace the entire drawer track system of my Lexington dresser. I have some questions: If I use your dresser track replacement kit, does this replace the dresser track AND drawer track? If I understand the videos right, the kit gives me a new track for the dres ... (cont.)

I would like new guides for the drawers and the slider bar for the whole dresser. Can you advise me on the parts that will work? Thanks, Cory