Viewing all customer Discussions for:

32-053 Drawer Track Kit

Hi there. Updating a very well built mid century desk and hope to replace all the ball bearing slides. Photos are os the smaller drawers just to see if you can help. The larger ones (not shown) all say Grant. I know they are from the 70's-80's era. The desk was built around only having limi ... (cont.)

Unable to find plastic guides on cabinet where plastic drawer goes. Unfortunately I am unable to figure out how to attach the photos I took because I can't find this message when I return from photos

Please review the image of the part that I need a replacement for.

Hi, I have been researching how to replace the entire drawer track system of my Lexington dresser. I have some questions: If I use your dresser track replacement kit, does this replace the dresser track AND drawer track? If I understand the videos right, the kit gives me a new track for the dres ... (cont.)

I would like new guides for the drawers and the slider bar for the whole dresser. Can you advise me on the parts that will work? Thanks, Cory

Broken guide on back end of drawer itself and broken guide on the dresser guide as well. Toouch down pressure when drawer was open likely caused the breaks.

I need a bottom mount drawer slide for a Thomasville dresser. The part that attaches to the bottom of the drawer about is 15"long and the part that attaches to the dresser is about 16" long. It has a small slide with four ball bearings.

I am trying to find replacement drawer guides

old school olde-rite.pat .mfr332201 17 1/2" bottom mount drawer guide. need 21 1/4" length .These guides were made by ken enterprise incorporated highland park Illinois.

These are from a company called etc Childcraft, and these are locking drawer slides. I don't think I need them to lock, but they won't stay in. When you pull the drawers out. I understand this company has been closed so I'm looking for a replacement to be able to fix the drawers. Thank you Carol ... (cont.)

the part is 32-076 but it has rollar in the middle

The part is 17" long. Angle up in back to screw ow. That's what broke off

I need the part that has a roller in it

These are the rollers on some 1940's scratch-made cabinets in my house. I have replicated the style of construction in some new cabinets. I am trying to find this type of roller to complete the project. there are 7 new drawers. each would require one of the center rollers mounted to the drawer i ... (cont.)

I need the 17 inch slide for a 1985 Thomasville dresser

I have a circa 1960s Broyhill high boy with two top drawers each with bottom center drawer glides with a one inch wide rail and are 13 3/8 inches long. The rails inside the dresser are squared and don't have any indentations or grooves along the side lengths. The drawers slide easily but when pulle ... (cont.)

Read drawer glide with roller, and metal track Only marking: PX IND. INC

I need to replace a number of drawer slides for an old Thomasville dresser. The old ones use a ball bearing system - I uploaded some photos. Need either a direct replacement or something similar that will work for me.

I was hoping to replace a singular drawer slide on a drawer that is 36 inches wide by 14 inches deep. The current singular slide (wood on bottom & metal on top) does not seem to be able to properly support this large of a drawer with even a small amount of contents.I was hoping to change out the ... (cont.)

Missing one of the pieces of wood for the bottom slide. Do you have something I could buy to fix these. The rest are worn, so I would probably replace them all.