Viewing all customer Discussions for:

32-062 23-5/8" Self-Closing Drawer Slide Pair

The bracket broke on another drawer. Slips into an "L" shaped opening on the side rail. Hardware from 2001.

Hello -- I need a replacement door slide for a Kraftmaid kitchen drawer as shown in the attached photo. The door slide is 23 inches long without the end cap and 23 and 5/16 with the end cap.

Do you know where I can find a replacement drawer rail that fits into one of your brackets? The rail is 23" long.

I can not find any quite like these. The roller wheel is on the outside of the bracket. This roller in the picture goes on the right rear of the drawer. All I see are backwards or have the wheel on the inside of the bracket. I do not see a way to modify and use those. I have dozens of these and ... (cont.)

Plastic mounts that hold track to the side of pantry Slide out trays

How do I remove the rail from back bracket. if I cant, can I remove the back bracket completely and get a full set to replace?

Need to replace rear hanging plastic drawer bracket (right side), please help!

Hello ! We need one of these drawer parts. It came with our Project source cabinet we purchased from Lowe's.

Our drawers are 22in and the cabinet is over 23in from the face to the back. Trying to find soft close replacements since these are over 15yrs old. Attached are photos with the measurements and of the current sliders. Thank you.

I need to replace my 23 inch drawer sliders. My kids bent them. I'm not sure where I bought them from Home Depot or Lowe's.

The sliding drawer back right bracket from one of our Mastercraft drawers broke. Do you recommend a replacement please?

Drawer roller

Corner mounted bracket for kitchen drawer, wheel has broken off, will need both corners. Top of bracket to center of wheel is about 2.5". Happy new year!

I have looked at your dimensions on 32-018 which handles a slide 7/8 inch tall and 32-089 handles 1 inch slide. I need 1 1/8 inch for my slide to clear. Is there a brace that will handle that?

Your 19-5/8" drawer slide appears to fit my kitchen drawers perfectly, but the cabinet box requires a 22-7/16 inch cabinet member slide for the drawer to go into. In other words, there is a several inch difference between the drawer size and the cabinet depth. The original slides are Grass 6600. ... (cont.)

Kent Moore Cabinets. The part does not use screws. It attaches to two holes at the back of the cabinet. One drawer fall. The others have not but most are damaged. I would like to get parts for 6 drawers.

How can I order all the drawer brackets and plastic back brackets? The stamp says UNIGRASS 6600

The slides on the drawers are 19" and the only markings are G* and RD39-01 and LD39-01. The brackets that attach in the cabinet are 23" with no markings. They actually look to be 24" with the end bent so they fit into a plastic sleeve on back of cabinet.

Need to replace some draw rails see photos can you help?

I have an old Merrilat slide, and the socket broke. I don't know if I can just replace the socket, or the whole slide. The slide that attaches to the cabinet is 22-1/2" OAL, and the slide on the drawer is the same. The socket is a bit funky, and I believe it is no longer made. If I need to replace t ... (cont.)