Viewing all customer Discussions for:

39-036 Truth Hardware Entrygard Dyad Window Operator

Please help me identify replacements for this hardware. Thanks

Large dual arms 7in and 10in (other dual arm operator is slightly smaller) Othe cranks are 10in and 4 inch.

Part number on the arm is 30744. What window crank will work.

Hi! Need hel in identifying this

The casement operator I need to replace was made by Truth. It is being used on a long, narrow window (10 5/8" x 75 1/2") between two french doors. The operator is about 5" wide and about 2 1/2" deep. I see the following numbers on the operator: 30471 -- on the rounded hood above the worm drive 306 3 ... (cont.)

This particular unit does not have any name on it, but the window has four operators. Two on the left side of the window and two on the right side of the window.

The Arma that ataches to the window is aprox 4 and 3/8s

Hi. I have 2 70" tall x 27" wide casement windows with operators like the first 2 pics and then 2 that are 31" r tall by 16" wide and their operators are like the second 2 pics. Can you tell me which operators to order? I need a L/R pair for each set of windows. Thanks VERY much! ... (cont.)

The above pictured Truth mechanism on my Marvin Bay window (left looking out from inside) casement has stopped working. I believe the Marvin serial number is 01 1G 00 OBA IGMAC, however, I'm not sure if the 00 are CC because it's really hard to see.

Hi ! I need to replace some broken and stripped operators but I am not sure of the part#. Could you point me in the right direction?

Here are a few new pictures. Model ? 3084IL or 3094IL and 20810?

I can't read the final letters/numbers on the assembly due to rust. I think it is ZO. Those last two appear to be letters as they were thicker than the numbers. We have not removed the assembly so I don't have a picture of that but we did take off the "cap" hiding the mechanism and I've sent a pi ... (cont.)

Hello All. I am looking for the below part. On the left control arm, there is a stamped number:5084L Thank you for your reply.

What type of hardware do I need to replace this?

Pat no. 4.840.075 There is a number 45275 on the frame 31782L on the gear Says EntryGard by Truth

This appears to be a TRUTH EntryGard casement operator. From the picture, you can see it is stamped 45275. It has two arms, but, unlike any of the EntryGard operators I've found on the internet, one of the arms on this one (the arm which goes in the rail), is short and is attached near the hinge edg ... (cont.)

Stamped on the assembly is "Truth" / Pat no. 4,840,075/ Made in USA. Also on one cogwheel is the number 3136 although I am not sure of the last digit. The house was built in 1996. Thank you for your help

Looking to replace window latch

Hello Would you please advise on which crank operators would fit my Truth arms. I was looking at the conversion kits but open to whichever will fit the new arms. Thank you

I was going to order these but wanted to know if they were the correct parts for my kitchen window. The gears shredded and crank handle just spins. Thanks! LEFT SIDE https://www.swisco.com/Dyad-Window-Crank-4-inch/pd/Casement-Window-Replacement-Operators/39-036 RIGHT SIDE https://www.swisco.com/Dy ... (cont.)