Viewing all customer Discussions for:

Door & Window

thank you for your help with this

Hi, Can you help identify These cranks Thank you

I have seen some glazing similar to this but, what is needed has a small 90 degree edge on the small side. It's about 3/32"

T-lock shoes look to be 1-1/4" Let's do 4 appreciate your help!

I need the handle & slot it goes thru window will not stay open something is broken

Locking mechanism no longer slides tried lubricating it still does not slide. Would like to order a new piece. Cannot find any numbers except DNS industries Miami Florida house was built new in approximately 1983.

I have Feldco windows and one will not stay open. I found some broken parts, the bottom bracket and I think the other parts are some type of springs. I don't know if the label has any info that helps, but I included that.

has number 102. Goes on to side of window to connect it with the track and springs

The lock is sticking

On the coil spring it shows 5EH. I could not get all the parts out of the window for measurements

I need 5/8 Top Sash Guide but the one I need is inside the frame with the tao shaped to fit inside the frame profile. The hole is like 1/4 not 1/8 comparing with yours 18-063. Please see the pictures the bottom is bend. 5/8" Top Sash Guide

The door is an Amarlite, thank you 36x81.5, left hing, red new hinges and thresholdDoor sits flush in frame, not recessed 1/8”

Photos show window top balance stop clip.Please identify for ordering.Thanks, Steve

Hello, I have several channel balances that need to be replaced. All the windows are of the same non-tilt design. The balance that I have is 30" long and stamped with 29 4 DT CMC 4. Attached are the pictures of the bottom and the top. Thank you very much, Vladimir

I am trying to purchase an external standalone pull handle for a sliding glass door. A picture of the external oull that i am looking for is included. I also attached a picture of the interior hardware. ChatGPT identified it as made by Arcadia, and suggested I contact you. Two of my sliding glass ... (cont.)

A tall American Craftsman vinyl double hung window installed 2011. Believe need 2 pivot shoes and the stops with the coil springs that attach to them. Also looks like the bottom right pin which goes into the pivot shoe is broken, is that replaceable?

Hi I newed a quote on Window balance . Let me know if there are quanitity discounts The balance is 25 inches and has 24 3 stamped on the side

Need 28" long channel balnce replacement

This part is to hold the old model metal closet bifold doors in the bottom rail track

I think it says TRUTH on it