Viewing all customer Discussions for:

Door & Window

Hello i have two windows that missing molding, which holds window lock closings. Basically i can not lock my windows Both windows same size, so missing 2 identiacal parts: American craftsmen 52inc x 61.875 in 70 series low-E argon glass single hung white vinyl impact FL Lange window Model: 70 SHFL ... (cont.)

Hello need to see if you are able to match this t-handle.

Older sliding aluminum windows with handle and locking device. Locking device does not work to open or close.

I need a handle with lock but I don't know the brand. Your help would be appreciated greatly. Thanks

The housing top to bottom is about 1 1/32" and the wheel extends below the housing to a height of 1 1/8" overall. The housing is 9/16" thick, except that the edges of the ends of the wheel axle sit outside the housing and are probably 1/32" wide each. This is a Michigan Door, a company that I belie ... (cont.)

The window to the left of this one is .missing the complete lever,, need to be replaced

Do you have a replacement receiver

Hi, I can't find a part number anywhere on these patio door wheels? I believe the wheels itself is nylon, but a steel replacement would work. David

Hello, I have Anderson Silverline windows and need tilt and lock replacements. I've put them in a cart but are these the correct ones? Photos of my window parts and what I added to the cart are attached. Thanks!

IMPRINTED: There is a 2-line imprint above the peg itself that says: 1st line PAT'D 2nd line P.X.IND. PEG DIAMETER: Including gear-like protrusions " is 1/4", not including them is 3/8". DIAMETER PEG HOLE IN CABINET: About 6mm. QTY TO ORDER: Either 10 or 32 or whatever is closest to ... (cont.)

Hello, Looking to replace this part for my windows. Part #2630 BSI DO

Hi, Channel balance of one of the windows broken. it is 32" 10/60th of an inch long. There is number (photo #1976) has 32" 6 BSI OD. Not sure what the right size/product?

As seen in the pictures I am looking to replace the crank operator for both right and left window panes.

26 4 cs

Length: 19 5/8 inches Stamp: "19 2" Needed: 2 balances (or 1 if 2 isn't possible)

Please call me. Bobbie would like to get a replacement ordered.

Hi, the window crank feels stripped when I try to open it. I am not sure which operator to purchase. The numbers I pulled off the window are 11967, c2-045, and cw2-cw3. Any help is appreciated. Thank you

We have not removed the parts yet. Are there part numbers on the Truth hardware? Thanks, Mike

On the side of the metal is the following: 25 5 BSI PE The metal is 1/2" wide and deep. The length of metal is 25 5/8" The length of entire unit is (which includes the plastic ends) is 27" The windows themselves are Milgard.

The plunger on my bottom latch is broken