Viewing all customer Discussions for:

Door & Window

Replace the old handle

I am in need of a replacement lock, I have searched the numbers on the sticker but no help. Can you please help me? please call or email me, thank you.

Looking for replacement

Good afternoon l need help with identifying part and pivots to go with it . Thank you

Hello my name is Pedro, I need to replace this channel balance with new ones. pleased advise.

Hello, Do you have this roller ?Thanks!

please match my hinge with a slow close I am trying to avoid mortising out anything for a new hinge

Good morning, I am looking for a replacement corner of keys for a couple of screens. The corners are 1 inch The thickness of the key is 5/16 The width of the part that slides into the metal frame is 7/16 as shown in pictures. I’m hoping you have 8 to 10 available? Look forward to hearing from ... (cont.)

I need help finding a replacement part. Please see the attached. Thank you Unfortunately both sides are cracked. Take your best guess, it will be better than mine.

Looking for a replacement for this window crank. It only has one arm, which has a pivot in the middle. Sorry for not including an image of it installed; hope these photos work. The cowl or whatever that goes over the crank/gear does not come off.

I have been unable to locate any manufacturer information on the door or the rollers. Bearings are bad in both rollers This style uses tabs to hold roller assembly in the door frame. It does have top screws just the one bolt on the side below the adjustment screw. The track is worn as well as the f ... (cont.)

Sliding door wheels. Two pairs. Attached is one of the pairs I removed. The bearings are wasted.

Greetings. We need to source the handle in the attached photo. We are a 192 room hotel (Pickwick Hotel) and will need several of these.

Look for replacement glazing bead. We think the windows are either Anderson or Jeld-Wen. Marking in the glass spacer bars read "B09988x26B2"

Could I get help with a replacement part? The window was made in October 2006

Hi, I'm battling to find tge replacement rollers for my sliding glass door. Roller is a tight fit in a 1 1/2" x 13/16" opening in the bottom frame of the door. The top of the assembly has to be open to allow clearance for the door frame screw (where there is a notch. Thank you, Myles ... (cont.)

Hi, I need this part. I believe it has one on each side of the window. The length of the channel is twenty nine inches.

Pivot shoe

The balances that I have taken out of my single hung Milgard windows are marked 26 4 AW CMC 2. The metal portion of the balance is 27" long 1/2" wide.

lookig specificaly for the cover