Viewing all customer Discussions for:

Door & Window

Looking for balancers for Semco windows

The bottom windows will nor stay up. The tab is broken that holds the spring to the inside of the framework

Have Nani insulate 460 slider how do you adjust for easier to open

This balance went to the top of the channel after unlocking the sash. I can see 26C on it and I think above it, it says BSI.

Need to replace unit on left window. Need covers for left and right crank assembly

Hi there, We ordered (14) 91-179 slide bolt assemblies. I tried to install them in our existing storm panel frames. They will not work with the existing frame corner keys. The existing corner keys are 5/16" thick. Our existing slide bolt assembly is about the same length as yours except the tail whe ... (cont.)

Cust was told existing is obsolete and gave her this item for replacement. Do you happen to have the replacement as well? Made of the highest quality materials, the Truth Hardware Ellipse Single Arm Casement Window Operator has provided years of continuous and trouble-free service for our customer ... (cont.)

The pin broke off the base plate the window secures to. Windows or approx. 35 years old. I believe they are crestline

I have some Stanley windows (approx 20 yrs old) and the sash brackets are rusted and falling apart. Do you sell replacement hardware for this style of window? The crank operator is fine and does not need replacement.

All of these are going out in my house. I need to find replacements please. Can you help me locate from your inventory? Window tilt latch, one end oval. casing length 2 13/16 casing width 12/16 height including top lip 9/16 Height without top lip 8/16 edge to point is seven or 8/16 wavy lines on ea ... (cont.)

Length = 29 5/8" Stamp = 29DS 40 Qty needed: 4

Hello, I have a window with a missing balance (I believe channel). Can you help me identify which part is needed? I recently removed the entire window and there aren't any identifiable numbers or other markers.

Is there somewhere near me that I can go and look at the lock to see if size is the same as mine

The Viking window metal shaft is 24". I'm looking for the correct replacement for my window.

I need to order 2 pivot bars. I think they might be 3 1/16 inch. The other part of the bar broke off and fell inside window. See photos.

I'm looking for a top and a bottom roller replacement parts for a sliding glass, aluminum frame closet doors

Balance is 30 inches

1981 Palm Harbor mobile home. Need replaciment window latch.

Mine broke, it is 2 screw hole, 7/8" large end, about 1" on the sides, 5/8" smaller end, about 1 1/2" long, with a shovel end, in the middle it is solid,(not a see thru slit..like your foto looks like); your # 18-064 looks like the correct replacement, is that right? Thank you Marie ... (cont.)

I need to order a set of spiral balances and a charging tool red cap 17" 3/8" diameter