Viewing all customer Discussions for:

Door & Window

I need a replacement Entrygard bracket left hand opening. 2 3/4 x 1 3/8. I found the number 2081 printed on the right hand opening.

Please identify so we can order.

Good afternoon, I need to replace this lock. The photo shows the one I need, I would like to know if you can help me Regards Jose

Letter V stamped on side

It appears to be all in one. Sits into the top frame of the pvc,plastic like door.

Channelenght 14 and 1/2 stamp 14 2,BSI. Need two Channel length 20 and 5/8, stamp,20 2 BSI Need two

I believe the parts I need are as follows (see photos): 1/2" coil balance, S160-06, 6.5# 1/2" coil single support, 15-150S 1/2" pivot shoe, 15-111 I intend to replace both sides.

What balance is needed for ID 29 4 EV CMC 7

Hi, I'm looking for internal replacement door lock. I believe aama any iinfo or guidance is appreciated

Lawson window. Single sash. 52 in width window

Hello, this Alenco door is about 40 years old. There appears to be a screw coming down from inside the bottom edge of the door holding the wheel casing in. I do not want to disassemble my door without a replacement part. It has a single metal 1 1/4 inch roller, length 2 1/4 inch long, 1 1/4 inch ... (cont.)

L=2 1/2 W=3/4 H=1 3/8 Wheel diameter=1 1\4

Is part 82-002 offered in white?

My balances have a purple stamp -- 27 4 HV CMC 7it is also 1/2" wide

The outside plastic trim of my door frame is falling apart. The door is a Malibu sliding glass door from Anlin.

Need to replace the whole bracket

* metal channel length: 26.5 inches * printed '2650' in big print and 'BSI' and 'RP' in small print on the metal * originally installed by pella window * for white vinyl sliding window * need 1 balance part

Do you sell a replacement for this part?

The gears have worn so that the part no longer closes the wooden window. The part number for the main crank is 40372 and its dimensions are almost 5" by about 2 1/16"; the arm or Entry Gard is 30472 and is approximately 9" long. The shorter arm is 20810 and is about 4 1/2" long. It attaches to the w ... (cont.)

Need bracket where handle attached to