Viewing all customer Discussions for:

Door & Window

I sent another message regarding what I believe is called the pivot. These photos are for the locking part of the window. We need the right side lock. I had more photos but your site only takes four. My dad does not know the brand of the window anymore.

Hi - looking for a sash pin for a Lincoln wood double hung window circa December 2013. I believe it may have been their part 104456

Would you kindly help me identify this part for ordering? Left side of the photo with a hollow us the top of the sash, it seems to be a horizontal plastic water drain channel. This is the tip sash guide of a Milgard 2003 window. The balance pops out due to the blocking top flat section having bro ... (cont.)

One photo show two broken pieces put together to demonstrate the length; the other photo shows the two countersunk holes on each end of the 'bar. The countersunk holes are on opposite sides of the bar at each end. 2 holes are screwed into the frame while the other two are screwed into the horizon ... (cont.)

numbers on the top 26 2 rsi pv

The screen frame says Made In North America there is a hand written number on the frame, Q50400-2-14The ones I ordered are too small and are sloppy when inserted into the frame. On the Corner Piece itself stamped Les Products

Need a new lock

Can you let me know the part numbers to replace these Pozzi casement window locks (left side) and crank mechanism? I think we can use the existing crank handle and cover. Thank you.

casement window operators parts as shown on nte ;pictures

These are for the original windows when the house was built in 1998. Any suggestions for a replacement project are appreciated. Thank you. Eric

I am looking for a few replacement roto window operators for vinyl awning windows. They are stamped as Truth hardware and 2 separate numbers: 31881 and 41010

We have Millard windows home built in 1999. What channel balance do we order window is approximately 25 pounds

The roller shown in the photos is from a 5' wide metal sliding door installed 8n about 1984. The door opens from left to right and the roller is at the bottom left corner of the door that slides. There are two pieces and the inner piece has A S stamped on it. The actual roller wheel is gone ... (cont.)

Part number 4 5015 on bottom of latch (See picture) For Pella single hung wood window lock/latch from 1990s? Need two of these. Not found on Pella website.

HI, CAN YOU PLEASE HELP ME SELECT THE PARTS I NEED FOR A NEW SCREEN REPLACEMENT. THNAK YOU

can not find matching gazing bead. do you guys carry this part

I have window balancers that are 2630 with a top guide of 19-001 and bottom guide of 15-008 I do not see any where that you have them already preassembled can you help or would I have to order the individul pieces and do them myself?

Hello. I have an older window and the hinge arm got bent. Looking for a replacement part if possible.

MODEL # PELLA-PEL-0705-D2CSF3P1Z1-144A095ITAN-525SV15S-NFRC IM LOOKING FOR THE WEATHER STRIPPING FOR THE SADDLE OF THE DOOR WHERE THE SLIDER MEETS THE SADDLE AND THE STRIPPING THAT GOES TOP TO BOTTOM WHENM THE DOOR CLOSES.

Good Morning,Trying to determine what model of awning window operator this is, as I need 2 replacements. I believe they are the Truth brand. Not sure if my pictures are specific enough to determine this. Let me know if you need further information.Scott