Viewing all customer Discussions for:

Door & Window

Identify Channel Balance, 16 inches, 20 inches Ticket# 36789948

We believe these parts may be designated 017VD000 - Pella Lock & Strike Pkg, Champagne (1995-2004). Each part is 2-1/4" wide. We actually only need the strike if that is sold separately. Thank you for your help!!

I need a tilt latch like the one in the attached photo. It's 2-5/8" long and 11/16" wide. Does Swisco have it?

The installed part is on the left as one looks out the window. The larger white colored part that is the cover has the number 8300(dot centered in the line)02. The smaller bare metal part which I guess sits in the inside of the mechanism and is either broken or missing another part has the number ... (cont.)

Pat# 5.353.548 for one of the balances. Both window balances are broken. The single metal band is snapped in half on both sides.

Hi, looking to find a replacement for this old corner key. The square, corner portion is 1" square and has a groove to hold the spline. There is an old tab to hold it in a channel on the top of the screen channel as well as one on the Inside. The inside channel measures 1/2" wide, with a D shape. Ap ... (cont.)

My locksmith instructed me I need the following lock for a very old sliding glass door. Guardian ANSI Z97.1-1984-SGCC 1630 6 CFR 1201 II 2397. I have been unable to locate this on the Internet. Thanks,

I'm looking for patio screen door replacement wheels (this is information was on the label in the patio window that was installed photo 1 shows the actual label: the window series 9500 Vinyl Patio Door PL# 073-302 the AAMA code: ADW-4. The photo 2 is how the wheel was installed, photo 3 is how it lo ... (cont.)

I have Vision 2000 windows which are no longer made. Do you have any idea where I might find the inserts for the small weep holes at the base so bugs can't get in?

Fits into the top of a door jamb.

Jamb liners are 46-3/8" on the long dimension. 15 degree sill angle. "Vee" plough. There is a "20HD" stamp on all the balances, followed by a "K%" or "K7" (or something close to that, shown in attached picture). Double hung, tilt out, compression fit. Approx 3-5/8" wide flange to flange. ... (cont.)

Can you please identify what part this is? We believe it to be a pivot pin

S795-35-Q0352 Name: 38F SEries 795 with a 15-198 hook 15-195 shoe Quantity: 20

Trying to repair a screen door with a busted roller. The door is an Eagle brand which I believe was acquired by Andersen.

Complete 36 1/4 x 17 3/4 window screens (Replacements) for casement windows

Hello I have a house in Nassau in The Bahamas and getting ready for Hurricane Seasons just had work done on my windows I need three of the hinges and a few of the parts for spare. We dont live far from the ocean and these wear out quickly - I will be shipping to Atlanta GA thank you ... (cont.)

Hello, I am hoping to find this part for several of our windows. They are original windows from when the house was built in 1997. I am not sure that this part is still available and hoping that you can help. Thank you so much! Best wishes, Lori

Where can we find these roller inserts for metal frame slider?

I needed the left and right spring. Window measurements width is 33 3/4 and height is 36 Thanks

I sent another message regarding what I believe is called the pivot. These photos are for the locking part of the window. We need the right side lock. I had more photos but your site only takes four. My dad does not know the brand of the window anymore.