Viewing all customer Discussions for:

Door & Window

Do you have this window handle turning spare part?

Channel balances in both windows are 28” long (metal portion only) and 29” long with plastic fittings. The bottom shoe on all channel balance fittings measures 1-3/32” depth. Both windows weigh 35 pounds. Window A Stamp: (Side 1) 2790 BSI PN 30 and (Side 2) 2790 BSI JN 30. Window B ... (cont.)

This client looking for this type of rollers and stoppers

need help identifying this pivot bar.

I need 2 sets of these

Hello I'm looking for this operator on the left and right side, The long arm measures 5 3/8 and the short measuring it from the center measures 4½, waiting for your prompt response. Thanks

I have a casement window with truth parts, probably 30+ years old. Original to the window. The window cranks open but the crank doesn't work at closing. There are multiple part #s: 6993, 20810A, 31538A on the 3 parts. See photo. I think the gearing has worn and I need to replace those pieces N ... (cont.)

Need to this pin. I don't know manufacture of my windows It measures approximately 2 7/8" by1/2"and 7/8"tall

I need a latch just like in the photo. I think the dimensions are the following: 2 x 1 x 5/16 or there abouts. The latch is needed for a set of older windows. I bought latches from from Amazon that were similar but not exact copies of the latc, but they did not work. Lowes and Home Depot only had la ... (cont.)

i am looking for a patio door handle , for patio sliding glass door (all parts ) Thank youIrene

Window balance and pin also latch's needed for vynil single hung windows

I am looking for the proper part to replace this channel balance. Thank you.

32 4 JV CMC 2

28 inch in lenghth metal to metal. Heavier window.

I need some information on how to order these parts for the window.The window sash weighs 14 pounds and I would like to order both sides of the window side Coil and top and bottom pieces.

Do you have this balance shoe?

Do you have these

I will need 2

Looking for this plastic part that fits over the interior glass as a molding. Thank you

Can you look at this constant force/balance and tell me what parts I need to keep it in the tension position