Viewing all customer Discussions for:

Door & Window

Greetings, Would like to order replacement hardware for these windows. The screw pops out on 3 out of 4. Any help on what parts I need would be appreciated. Best, Paul

My son in law is looking for this, do you have one? Thanks

Need a part for upper and lower hinge for this particular brand there's a brand name on on the bottom of one of the picture

Hello, I need to replace a right and a left Truth Entry Guard operator. I'd also like to replace the cranks and covers with folding cranks and covers if that is possible.

Can't find any manufacturers markings on this existing window and the crank assembly needs to be replaced.

Need new parts for both sides

I need about 4 of these balances with the part that holds the window. The balance has a 30B on it. Can you get these parts or do I have to go directly to Pella? Thanks

I need to replace a worn patio door latch. Inscription on door latch has AW (Anderson Windows) logo. The screws that hold the latch to the door are 2-1/2 inches apart. The handle that locks or unlocks the latch is loose, so I'm not sure which part is defective. Maybe best to replace the parts in t ... (cont.)

Hello I'm try to find replacement locks for awning windows. Please see the photos and let me know if you have these. Thanks

Hi,I have attached a few pics which I hope help but I need to get replacement parts for the:Pivot BarPivot ShoeBalanceThe window manufacturer is Simonton Windows.Best,Paul

Looking for your part # to order 2 new Channel balancers. 29-9 BD5 CMC 87. See attached Pictures. Thank You Mike

Good morning, I need 2 coil balances and 3 pivot bars. Can you point me in the right direction? Thanks!!!

Good morning, I would like to request a quote for 8 channel balancers. Please see the attached photos. Stamped size is 27 1/2". Please advise on lead time as well.Thanks, Nick

I need to replace a woodbine ind patio door latch. It's dimensions are exactly the same as your part 82-002K except that my part's width is 7/8 inch and yours in 1 inch. Do you think it will fit?

I'm looking for window corners. I sent photos of half of the corner I need for the screen. The photo is the measurements of the outside corner to outer edge and thickness of the plastic corner is 1/8x3/8 thickness if you need information please call me

Looking for this item for home built in 2005. The length on top from end to end is between 2 11/16" & 2 5/8". Width 3/4". Height of rounded bottom section is 3/8"

Manufacturer unknown

These snap in safety stops come in 4 inch segments on our windows. I would like to purchase longer lengths, which I can cut to length to provide security-stops, allowing our windows to securely ventilate at night.

I need some help identifying the right rollers. The dimensions for the 81-051 seem too big. The roller opening on the door measures 4 1/2" long by 3/4" wide by 1 1/4" deep. The rollers are mounted from the top and there is only one hole on the side of the door for the height adjustment. ... (cont.)

Unknown window manufacture. All 16 windows have the same problem of latch failure.