Viewing all customer Discussions for:

Door & Window

We have installed impervia doors and it seems the wheels on the large slider thump when sliding like cupping on a car tire. Do you have replacement wheels. Installed around 2004 ish

Have a 3-4 of these that a painter lost in a remodel. Any chance you all have them or similar that we could replace with to make the units while?

I have Crestline double hung windows that were installed in my house when it was built in 1991. The current problem is that the lower jamb in one window will not stay up when opened. I disassembled the window and took out the tension spring on each side and tried to get replacements. I could not ... (cont.)

This is part if a storm door with a slide down storm window that pulls down a retractable screen. The top sash cane off the window while lowering it. Trying to put it back together but one of the corner brackets is broken. Thanks

The item is 17 inches long....please assist Thanks

I'm looking for a replacement pivot lock shoe. The one I currently have is half inch thick. It is used in conjunction with the series 770 balance.

Looking for Pile type for around sashes and the bottom bulb weatherseal for 5500 series Simonton double hung windows. Can you help me? ThanksDave

I have old Andersen wood casement windows from the mid-1960's. There are slots on the inside of the sash that looks like a retainer clip would go there for holding in and interior storm panel. I can't find these clips.

Part is for mobile home window no markings on part.

We have a 20-year old house where the sliding door track cover pops out of place turns on its side. And as I told a Swisco agent on the phone, I don't think the track cover is actually covering a track. The cover actually looks like something I see on your web cover page, but I can't find it on you ... (cont.)

Hello! do you have a replacement suggestion for thee cabinet sliders? As you can see in the picture, the wheel is coming off and Houck does not make the part anymore. I am comfortable changing both sides to a new set, and the back plate is fine....thank you!Attached two pictures.Donna ... (cont.)

Number stamped is. 31 B. Than some kind of circle w/a design in. Than GR

Good afternoon,We have an MW patio door, during our move I had to remove the hardware to allow clearance to move furniture to our patio.Unfortunately, I have the hardware and I've lost all of the screws to re-install the hardware.Would it be possible to purchase all of the screws, several sizes as I ... (cont.)

4" between screws. Both sides

We just ordered spiral balances for several of our windows. I am looking for the coil that goes along with the spiral

Srings came from 2 windows same size 3 of the 4 have markings 22D and one balance has 22B

Hello, our Guardian patio door handle broke so I purchased a replacement. However I can not find a mortise latch that will fit. The inside opening measures exactly 3 inches yet most commercial mortise latches measure 3 15/16 etc, always a touch bigger than 3 inches. Where can I find a replacement? ... (cont.)

We are trying to find replacement hardware for this door handle - the handle on the left fell apart. I can't see any markings or model numbers on it.

I think I ordered wrong (2840) it seems.These are 29 inch long and 1/2 inch wide and has 28-C stamped on them.From above would you please identify what part do I need.Shoe is about 3/4Thanks,Bharat

2) Window replacement needed