Viewing all customer Discussions for:

Door & Window

Total length is 31". Shoe is approx 1 1/8" x 5/8". Sash weight approx 15 lbs. One coil stamped 5 one coil stamped 6

I purchased a 82-239 - Multi-Point Mortise Lock and Keeper, 9-7/8" a few years back that works great. Now my pull handle has given up. Any suggestions on a good replacement? White preferred. Needs to lock.

Need replacement stripping for Pella storm door 100803 90561 5036. Photo attached.

Please send quote and information on needed replacement

Need two of these left & right if that matters Cliff

I am having trouble finding these double hung aluminum window latches. Please assist.

I think I have 900 series windows nu air 25 years old need new balancers need four @1640 14 @ 2830 and two @ 2220

2970 is stamped on the side of the rail looking for a replacement part the bottom measures 1 inch

I been ordering S377 but need it with this tip instead

You can see the size of the bulk I need on my diagram. The important thing to know is I need smooth sides, not with a notches on it. This measurement has to be 13/16 of an inch..

The tip is an off white.

wheel is 1 1/2" diameter

Hello, I am looking to replace the handle on our slider, as the handle on one of our two sliders has sheered off after years of use. It appears to be a brushed nickel colorThank you for your help identifying the parts required to repair it.Dawn

We have a strange one here: any help would be greatly appreciated. Overall width of lock is 2 13/16" Overall Depth is 7/16" Holes are 2 1/16" from center to center. Hole Center to back is 3/8"

Hi, Thank you for your help. Please see attached pictures of the balance. The following is on the balance: 26F JB The window is a single hang silver line window. I believe is a 2900 series. Thanks

Having a hard time getting the antislam button to push in far enough so the locks can be engaged . Replaced lock on Atrium patio door with your 82-265 . Tried several different things and it's not working. Suggestions?

I have a broken part for a window made in 1982 by Kaiserhof Consolidated in Houston,TX. It is a plastic exterior window trim/glazing piece with dimensions noted in the attached picture. Do you have compatible part available?

Latch doesnt work properly anymore. i think i need your part 82-229 based on what i see online. Please let me know if i need anthing else to make this work. Thank you

Hi - I was looking to replace the glazing bead on an Alliance exterior window that has broken off, but I can't seem to find the correct one. Can you please let me know if you have this part or something identical to it? Thanks! Rohit

Do you know where I can find a replacement of this broken part?