Viewing all customer Discussions for:

Door & Window

I am trying to locate this screen door latch, but cannot find the brand anywhere on the door. Thanks

Looking for replacement parts for a single hung Capitol window. About 21 years old and springs are breaking. Not sure of the weight or model.

Looking for these

The inside of the hooks do seem to be about close to 6 inches apart. I've never bought one of these. Please let me know what other information I can give to help identify which part I need.

Hi - these are for Viking windows - house built in 1997. Best I can tell the metal part is 33 1/16" long. The only markings I see I included a photo of? 32.9 34# EQ Caldwell and the other looks like 32 ? EQ Caldwell. Help! Thanks.

I need replacement for handleset shown in pictures. Thanks!

Is this one size fits all what is this milgaurd window lock ...

Hi there!! Do you have sometime that will work.. This plastic back bracket cracked

Hello, I need to identify this broken coil spring so I can replace them all on a property. I have 7 days left before inspection, so any assistance so I can purchase them would be greatly appreciated.

I need to order 2 channel balancers. will you please send me the right part number so I can place the order on your website? Length - 24" Width - 1/2" Weight - 2340 Mfg - Windowmaster Thank you, Seth

Hello, I need replacement for a 28" window channel balance. Stamped marking is BSI 27400 or the last letter might be a Q, 2740Q. Thx

Markings - 25 4 CU CMC 2 Width - 1/2 inch Length 26 inch Thank you!

Hello,The window coil on one side is broken and needs to be replaced. Attached are the pictures.Thanks in advance for helping identify the parts.Ekrem

I believe this window operator is an Anderson. I believe these windows are original and our house was built in 1967,however I don't see any markings or numbers on anything. I did measure the arm and it's approximately 9in. I would greatly appreciate any help that I could get identifying the window o ... (cont.)

I need help identifying the window parts. It's the spring loaded parts in the photos. They hold the window up when it's open.

I have found no information on the latch and would appreciate any help find a replacement. One is completely broken and this one is not going to last much longer. Thank you.

The pin is 2 7/8" long with first hole from pointed end is 9/16" second hole is 1 1/2" from pointed tip. Holes are 1" at 1" cc. Width is 9/16". I am not finding this pin. The has a #6 or #9 depending upon which you view the pin.

I need the latch for Uniframe windows , 1 5/8 x 5/8

Hoping to get some help on finding the correct replacement part for this mortise lock for my sliding glass door. There are no markings/part numbers etched on the lock, so difficult to confirm. Thanks!

Hi, I am looking for a coiled balance assembly for the 6500 impact Double Hung Window. Below is the information on the window: CAR#1380-560 Model 6500 impact Double Hung Window. NFRC 100/200 CWS-K-28