Viewing all customer Discussions for:

Door & Window

I would like to get a new balancer to replace the broken one for my window. Could you please tell what should I order based on the 2 photos? Please let me know if you need more information. Thanks, Tim

Hi, Customer Service I am looking for this Window Channel Balance L24" W 9/16 D 1/2 (not 5/8) I will appreciate your help PA

Good Morning I have a series 800 SGD NFRC 100/200 MST# 62610 The wheels are not moving making it difficult to open. Are parts still available? Thank you Angela

Hello, I received a set of hinge arm assembly from Silverline, but it is not correct size. Do you have a left hinging hinge arm with dimensions shown in the photos? I believe the window to be Silverline C2. Thanks, Bob

Hi, I have a broken channel balance I need to replace. It is stamped 2830 BSI. I think this is equivalent to your model 380 Channel Balance? A plastic wing is broken off one side. I've uploaded some photos. Also, have some other windows with the same end shape that are very stiff and would lik ... (cont.)

I need to replace handle/lock for this sliding glass door. Thank you!

I need a lock handle/base for a NW Aluminum products window. Vintage early 90's.

Replacing the balances in single hung vinyl windows. original part is 33 inches long (not including plastic end pieces), 9/16 inch wide, and 5/8 inch deep. Stamped markings on part are 3230 BSI.

I have a truth hardware casement window hardware which has 30905 stamped on one arm, but I can't seem to find one with the piece at the end of the arm that screws into the window frame. Any ideas.

Need help on entry guard truth window crank. Can't seem to find right one have bought 2 and had to send back.

Just need inside door handle

We need 2 in. Folding closet doors knobs

I'm looking for fin seal strips for a Cardinal (I think) sliding patio door. Bottom fin strip is 1/4" or 7mm wide, and the vertical fin is 1/4" tall. Door height is approximately 76-1/2" tall. I also would like to replace the top & bottom rubber seals on the stationary door (where the 2 doors meet ... (cont.)

Need advice on what part is required replacing roller/s for an Eagle brand sliding patio door. Door was installed 2000.

I need to replace broken spiral balance. It has a red tip and the tube measures 22 inches with 5/8 inch diameter. Do you carry this length? And if not, what length should I order?

Anderson aluminum covered gliding door double hook mortise lock 12" tall with activation pin.

vandals broke window and parts of window frame corner clips , Ill be replacing glass wit poly carbonate ... need 4 of each to achieve my goal.... Thanks so much

Hello, my pictures are of the LEFT tilt window latch. Both left & right latches are located in the upper corners of the lower window. Im looking to purchase 2 sets (left & right) of these items. The pencil picture points to the area that slides into the window.

I need to purchase a replacement channel balance for a Viking window. It was installed when the house was built, in 1988.The nylon attachment atop the channel balance on the right side of the window (as you stand facing it) broke. The spring inside the channel balance broke too.The channel balance m ... (cont.)

Hi, Can you recommend a pivot shoe for the tilt window?