Viewing all customer Discussions for:

Door & Window

This screen corner is 7/16" wide at the corner section (including the ridge or lip) and 3/4" tall at corner section. The screen frame itself measures 7/16". Looking for corner keys with and without stops (need to replace all four corners).

Hi. I finally removed these top sash balancers. I'll need 12 so I hope they are available immediately. So glad I found your site. Thanks

I need the roller assembly at the bottom of the vinyl patio door. I'm including some picture. The cage measures 3 1/2" L, 1" H, and 11/16" W. Overall lenth of the whol;e assembly is about 4 3/8". Assemblies needed is 4 because I have two doors to work on. I have more pictures if needed but I couldn' ... (cont.)

I only lived in this home for one year but I was told that the windows were Pella. I can not locate a Pella part that matches. I was unable to identify any name or part number on the window. The home was built in 2006. The original screen clips were attached with a pop rivet but one has been repl ... (cont.)

I need two of these window balances. I don't know much about them but they say 6k of the copper piece.

I need to find a white keyed patio door handle for this patio door.

This is a latch and handle from a sliding door.SD-R50-1816-2426-72x96Danny

I have a sun room with Pella windows and sliding doors--about 25 years old. Two of the doors and three of the windows have blinds that turn inside two glass panels. Each of the controls, which are found in the lower right hand corner, of each door/window are broken and will not turn the blind. Th ... (cont.)

What is your matching part number for this item? The channel width measured 0.557" (on the channel metal side) to 0.649" (on the channel open side that which has an stuck out edge).

I have a broken take-out clip and a broken channel balance. I think the mfg is "Kinco". If you can supply I'd order two of each, just to cover me for future problems and/or difficulty matching new balance with olde one.

I have broken coil spring, this is balance assembly pat # 5704165 and 530csb

Rubber sweep seal is breaking off. The door is 36" wide

Hi - Would this fit Milgard's casement window crank?

Hi. Can you identify this glazing bead?

I'm looking to replace a Milgard window balancer that is stamped 26-4 HA2 CMC 24. 1/2 INCH channel.

Crank and handle. Pictures attached

HI there, the latch on my window will no longer retract so I can swing the window down to clean the exterior. I believe it's this part, but would like confirmation. https://www.swisco.com/Tilt-Latch-LH/pd/Surface-Mounted-Latches-For-Tilt-Windows/26-266 Thanks! -Brian

I need to replace the latch for a sliding door. I have attached pictures of the handle but the only part I need is the latch that broke. I ahve attached pictures of the entire handle mechanism. If I can't replace the latch I would need to replace the whole handle mechanism. Inside handle is part ... (cont.)

I need to replace the swing latch that's broken on a couple windows. The photos are of a non-broken one. Also, the knob that slides the bottom lock up and down has broken off. Your form won't allow me to add more photos of this part. Do you have these parts? Thanks so much! -Marla ... (cont.)

I am looking for a replacement plastic piece that holds in the screens