Viewing all customer Discussions for:

Door & Window

code on unit 24 Caldwell; metal 20 inches long; unit is 1/2 inch wide; bottom attachment is 1-3/32 inch; no bottom roller fitting; weight approximately 18 - 20 lbs.

I need to add privacy to a downstairs apartment.

I have uploaded the photos I think you need to identify and replace a set of old Caldwell window balancers. The balancer used for the photos was intact and functioning, but the other has a broken pully wheel so I will replace the set. The metal portion of the balancer measures 29". Do you have a rec ... (cont.)

Channel spring for insulate brand windows. 25 inch wide window. 1/2 inch wide channel spring.

Diameter is 0.5 inch. The length of channel is 32 inches without the attachments. Some letters are rubbed off. I think it says: 31-9 J?5 CMC

Do you carry this detach pin for a Pozzi window. Also do you have the window with the frame around just the window. Or something that works for either? Window is 33 1/2 by 17 5/8"

I want to match this crank handle for a replacement in the kitchen. And need to replace the crank handle and cover in the bedroom. Are you able to assist in helping me order the same ones? They are Truth brand. Thank you.

I am looking for this part

Which window balance best fits these pictures. Note that it is stamped 27D.

I meaasured 1/2" accross, is this something we can work with? I will be doing this project myself. I'm pretty handy. Is there anything you can help to make the install easier? I 8 windows to do. Catherine

I have a sliding glass door from 2000. The door lock has started slipping out of the slot years ago, but could always replace it. It is a single tab that fits into the door lock that you flip up or down. There is no identifying mark on it except for CD344. Would you be able to advise of a replac ... (cont.)

Can I use Parts # 39-375 and 39-376 to replace the folding handles for Semco casement windows, since Semco went out of business in 2019?

Channel length 23inches Stamped: 2240 Window manufacturer unknown I need 2 balances

I'm looking for a window part for windows that were installed 10+ years ago by Dabella. The piece itself says J12 7300 on it, but I've had no luck finding this piece or even similar replacement locks. Any help is appreciated!

Need a 9/32 splined hole

I need all the screws bolts also with this purchase. Thank you

I am looking for this 80's vintage center mount roller for a monorail drawer mount. The roller is braded into the metal hardware. The draw mount hardware has a lip that fits over the back of the drawer to seat an align the roller hardware. The roller itself is about 3/16" wide as you view it from t ... (cont.)

Could you let me know what part to order based off the 2 photos?

The wheel says Kilian and Toronto and Syracuse on it. The main part is just over 1" tall and it is 13/16 wide. The wheel is pretty close to 1 1/8", but is pretty worn down so maybe 1 1/4". It is all plastic except the wheel is metal. The screw in the picture is not the right screw, it is the wheel a ... (cont.)

Good afternoon,I am sharing the pictures I took of the old channel balance that I can't really figure about to locate the extract replacement on your website. Please let me know if there is any further clarification needed. I would really appreciate your help. thanksHabib