Viewing all customer Discussions for:

Door & Window

Trying to find window parts for windows installed in 2000 by builder. Balances, Shoes, and Pins.

I was unable to post photo. clip is white plastic or nylon about 1 1/4 inch in horizontal dimention. Clip has 4 holes, two of which are screw holes to attach to window frame. Clip holds long vertical metal latch bar. Bar is 1/2 inch wide

Not sure of the window brand. The shaft is 7/8 inches long. 3/8 inch splines. Haven't seen a handle that fits the shaft with 3 splines.

Looking to identify this trim piece so I can order another one and two handles that go with it

I have a few broken window shoes that I need to replace. I was wondering if you have these in stock or something that would work. Measurements are included in the photo. Thank you

Looking for 2 dasher keeper springs for a Series 2222/2230/2232 Hung P.L # 466-003

I couldn’t find the exact name or brand of my window, but the size of the broken part is approximately 2.3 inches x 0.9 inches x 0.5 inches (the largest rectangular dimensions).

Good morning, My name is Joseph. I'm looking to get this roller if you can identify it and have it in stock. If you could please take a look at the pictures and see if you have this one in stock, I definitely would like to get the replacements. Thank you and I look forward to hearing back from you ... (cont.)

Are the 747 t lock open cams universal? I know you don't sell but will any 747 open cam t lock fit? The tabs are broken that lock into my recessed groove on the channel.

Please see attached pictures. Need the following items Qty 2 Pivot Lock Shoes, Qty 2 Tilt Latches, Qty 2 Sash Pivot Pins. Pivot pins are missing on both sides of the window hopefully you can suggest a replacement based on the Pivot Lock Shoe pic?

Looking for a replacement

Original 60's era heavy aluminum sliding glass door. Need to replace rollers pictured. No markings on door for manufacturer or anything else. Roller says 'General Bearing Mineola NY'. Roller wheels are 1 11/16 inch diameter, and 7/16 inches wide. I think with a 1/4 inch roll-pin axle about 3/4 inch ... (cont.)

Thx!

Do you have a video for tilt latch part 26-234? Thanks Chic

No idea the manuafaturrer

replacement handle and lock needed. Need both right and left side.

Hello, Looking for help identifying the correct balance I should purchase. The channel width is 1/2" and length is 21". On the back is the label "20 4 GT CMC 4". Thank you in advance!

I have Andersen double hung top rail window balance coded for E87 9#27. Would the replacement be 24-939? What does E87 signifies? Thanks

Missing the push cover to unlock and slide window

19 5 GW CMC 11