Viewing all customer Discussions for:

Door & Window

HelloWe need to replace both of the channels in our window. The windows were manufactured in the early 1980s. The metal sections of the channels are 26 1/2" long. The back of the Channels are 1/2" wide and the sides are 5/8" wide.Stamp on the back is 2630XThanks Greg

#2021

Assuming it doesn't have a lifetime warranty, where can I purchase the following Anderson sliding glass door handle?

I sent a photo of the type of window and the crank does t work

This old door (25 years+) has a single roller on each side. Is it possible to get a replacement that has more than one wheel (2 or 4?) to replace it? Thanks! Mike

This is the lock for a window casement, I was hoping to find the corresponding opening arm mechanism.

Truth 30905 Window hinge on left

Hello Swisco.I am trying to procure four (with extras in case of breakage) cabinet support clips/shelf support for a Haas brand cabinet. The clip would need a 5mm peg size and the shelf itself is 3/4 inch. (The one from Haas came with an end support on some to hold the ledge in place, but not expect ... (cont.)

Looking to find replacement hardware for Certainteed vinyl new construction windows installed 30 years ago.

Need cover and handle crank for this Anderson window

This is the window screen retainer from windows fro 1988 can't find anywhere any ideas

I have 1 right and 1 left opening window crank made by Truth on my wooden window casements. Can you match the ones I have?

The latch broke off of my door handle and I am not sure the manufacturer or exactly what piece to order. This door is approximately 2 years old. I'm not sure if I just need a new Multi-Point Mortise Latch Lever or if I need to replace the entire locking mechanism. It is a square hole that the latch ... (cont.)

Looking to replace both sides

Looking for the shoe

Is this my first picture the same part as 26-352? I also need replacements parts for the circular thing that the pivot bar attaches to. The metal is starting to chip off.

I believe this comes from a Milgard casement window. The base (part number 90486) is 13 inches long. The shorter arm (the bent one - part number 31861). Is about 6.5 inches long.

Hello, I need help in identifying the following parts to be replaced on some old crank windows. The crank handle has a label of 40085 near the top and 22 near the bottom that you can see on one of the images. The crank has completely come out and I need to replace 8 of these handles. Also does any ... (cont.)

Jeld Wen single hung vinyl window String broke Need to understand which kind this is please It is 1/2 wide and says 24b and is not ribbed

Hello. I'm unsure of the brand of the window and I don't see any numbers or letters on the broken latch. I'm looking for the right and left sides. Please see attached photos.