Viewing all customer Discussions for:

Door & Window

I have a door with locking mechanism but not sure if these are standardized sizes. It?s a double hook mechanism

Need help identifying Correct replacement rollers, The salt air has destroyed existing rollers and I can't identify manufacture of door. Thank you MIke

The brass fitting is stripped and will not screw in

Swisco, I am looking for a replacement door handle assembly for my Cole Sewell storm door. The handle lost its spring meaning the handle does not return to position. I have attached a picture for reference

Do you have this Pella Door Sweep?

Weatherstrip for Pella Entry Door.

Balancers are broken need to replace for both windows. What is the part number I need?

I have a large window in my apartment that is missing the handle that is used to swing the window open (inward) so that I can clean it. I'm attaching several pictures to show where the handle fits into the window. Do you have a replacement handle to fit my window? Thanks, Charles ... (cont.)

Hi, I have a Certainteed windows the part above broke, I ordered from your website part number S170-263 coiled balance spring my husband installed it still not staying up, what is your suggestion. The picture of the coil I have uploaded says on it number 10. Thank you

Have a vinwinco window with broken pivot bar. Need a replacement, 26-449 doesn't quite match. About 5.75cm/2.25in overall length

I have ten Milgard windows installed in Sept. 1988. Window Two (photo) is large, 58" X 58". The vinyl beading has cracked and weathered. A sticker on Window One indicates the conformity to ANSI/AAMA 101-85 with Series 1120 HS-CS0 MST 8054. There are spacers inlaid(??) at the base of the ... (cont.)

Can?t find a roller to fit my door

2 1/2 in back screw centers 3in handle Bronze

I believe the required information should be on the labels. I have been unable to identify the door manufacturer but would like to install a key lock on the current handle. Please help in identifying a suitable part. Thanks!

Could you please find this roller for my sliding glass door? It's broken and I need two of them. Thank you.

Hi need help with broken channel of one of my window ( see pictures)window is non-tilt, .5 inch (milgard)most probably it would be 380 0r 385 but not sure.https://www.swisco.com/cl/Series-380-Channel-Balancesalso length of my channel ( steel portion excluding plastic) is arround 29.5 inch. should i ... (cont.)

Pivot arm keeps popping off. All of the other arms have some sort of snap cap button holding it in place. Trying to find a replacement piece.

Latches are white. Approximately 3 1/4 inch long and approximate 2 inch apart for holes.

I need a left and a right replacement.

Do you have this part? Thank you, PAD