Viewing all customer Discussions for:

Door & Window

We have several Acorn windows in which this piece is broken. Can you tell me what I parts I need to replace it? The house was built in 1979.

30.75" in length from plastic tip to tip. Aluminum piece is 30" in length x 1/2" wide. Spring is 18". 9230 is stamped on the aluminum. Also need the two plastic end pieces shown in attached picture.

Roller is 1" and plastic. Width of bracket is 1/4", and overalllength is 1.5 ( just the bracket) manufacturer of door is unknown, probably early 70's

replacement pivot bar

1/4" dia pin 1/2" pin length 1-5/16 top leg 31/32" side leg with screw hole 1/4" x .175" leg thickness

Several of my window balancers are broken, difficult to raise and lower, and in need of replacement. I need some assistance to identify the correct replacement balancer to order. I have two types of windows and the balancer length measures 29 1/2 inches and 29 5/8 inches. The stamps on the balancer ... (cont.)

looking to replace some of our Roller Assemblies, they are 1-15/16" Long at the base, approx. 5/16" wide, and 1/2" tall not including the 2 prongs that snap into the window frames. They have slots for 4 rollers but they only use 2 rollers in each one

I have some Alenco Windows that were installed when house was built in 1989. I need to repair the vinyl glazing bead. I will need th color in black. I am very handy and can do most home repairs. Please look at attached photos.

This is an old wooden 1960's sliding closet door. The pictures are of what's attached to the top of the door. This part gets hung in the glide that's on the rail. My husband is holding the part that fits into the glide - it is broken off, he is just holding it where it should be. Do you happen t ... (cont.)

Can you get this? Thanks

Extremely old slider door with no identifying markings or manufacturer. Need 2 wheel assemblies. Height 1-3/4 Length 3-1/2 Width 7/8

I need to ID the parts needed in the attached photos. I need the pivot shoe, which is around .5" thick and the part that sits in the Pivot shoe. Thanks for your help.

Looking for replacement corner guides for our combination windows. They were put in back in 1980s and we have lots that have broken over the years. Thank you

Hi I'm trying to find this 3/8 inch corner with a curve to hook into a nail. See attached. Please let me know where I can find it.

Window Parts identify this as Craig having no vendor suppliers. Can you make or modify a block and tackle unit that could be used as a replacement? As a last resort do you have cord material to rebuild a broken balance and a worn out cord? Art

I need 30.5 crossbow balances, is there something I can use to replace them?

Right side of the window channel balance failed tonight. Once I got the part out I observed that the interior cord had parted. Looking for replacement.

Hi, I need replacements for screen corner latches with pulls, and the part numbers appear to be 842-2A and 842-3B. Would Product Code: 95-218 be an appropriate replacement for them? Thanks, Cary

I have an old storm door. This part holds the glass on the door. I believe I need about 8 total. Any help locating this part would be greatly appreciated.

We've got some quite old style sliding windows, they go up and down like in one of the photos. There are still locks working, but we could not identify the "Fentron" being a manufacturer. There is a photo giving the bottom (inner) side. This one has a broken piece though. For the ones missing, we ha ... (cont.)