Viewing all customer Discussions for:

Door & Window

This is the part I need, but there were two of these and then two shorter ones. Do I need 4 and cut them down?

I'm including a foil inspection tag with some part numbers. - Steve

Bonneville windows, double hung, tilt in windows. Wood interior. Balances are Unique 30D 40.

I need 5 hole plugs but I don

Hi, I'm not able to identify which spiral balance and pivot shoe replacement type to use as there is no color coding for the existing one. The current spiral balance is 28" long and 3/8" wide. I think the pivot shoe is 5/8", but couldn't get an exact measurement because I don't know how to get it o ... (cont.)

I need the lock mechanism also since it's also broken. I attached the picture here again which I attached last time when I order Latch Lever Kit. I need order 2 pieces o it.

I need a sash balancer replacement kit for a Anderson dbl hung window and the glass measurement are width 20 1/4

I need a patio door handle with a key st. and the patio door has a dns industries 13/25 outside pull and has stamp on it that says 1400 series. Do you think this would work as a replacement for my lock

I need 2 of these parts for one window. The old part number may be 961970

Looking for parts supplier for broken locks

Attached are the parts of double hung window manufactured by survivor window

CWS Windows-Single Hung-need to know if you have them in stock and the part numbers so we can order them. Thank you. 30 inches 29 9 BSI-8 Pieces 28 inches 27 5 BSI-14 Pieces Please advise.

I have several Channel Balances that are broken and would like to try a few sets of yours. Attached are pictures of the Stamp on the 27" channel and the end pieces. Channel is 27" Long Stamp on Channel is - 26 4 BS TD (with the BS turned 90 degrees counter clockwise)

This is a plastic Vinyl part that is on the inside of the sash. It is cracked and broken and the windows are foggy.

help

Sliding patio door handle with wood trim PT 1963 2

The cover for the window crank mechanism fell off and is missing. I need a replacement. I am sending a picture of the missing one and pictures of the other windows I have with the plate on them. Please let me know if I can replace that part. Thank you.

The 82-002 lock set shows that it comes with a lock keeper. Is this the 1/2 inch wide keeper or the 3/4 inch wide one?

I am looking for the window roller shown in attached pictures. It is for a metal sliding window set up. Manufactured in about 1987 +/-. Wheel is 5/32 x 1/2. Plastic is 1 5/16 x 3/8 wide x 7/16 tall. Have not been able to find anything on your site or elsewhere. Just have removed part photos. ... (cont.)

Need the LOCK lever.