Viewing all customer Discussions for:

Door & Window

Crank handle turns but without grip

I am looking for replacement parts for a slider and a window. I need two cranks one left hinge and one right hinged. I also need a slider handle to fit and match the exsisting handles. Finally the customer has asked for replacement screens for both the sliding door and the windows ... (cont.)

I am missing a couple of these...Do you have them?

I am having difficulty finding this part with the 1 1/2" measurement. All I can find is 1 1/8". I tried this size and it doesn't work.

Im in need of the two rollers for this Pella door please advise me of correct ones please as there are soo many.

The track on the window is L-shaped and it is 14 1/2 inches long and the arm on the crank itself is 19 1/2 inches wide tip to tip. The picture shown on the window is not the one I need. I need an opposite crank and track that opens left to right

I have multiple windows at my site. There are many of the same size,but as I make repairs on apartment turns. I'm noticing that the balances are all different lengths. How do I determine which is the correct length?

Please see attached. Thank you, please see attached photosof each of 2 operators. The measurements of the pieces for each operating unit are as follows (inches): 5.75 11.5 8.0 And 4.5 11.5 9.0 Thank you.

Lock mechanism normally rotates 90 degrees to lock door, but has broken off.

Good morning Have peachtree windows that tilt in. House was built in 1995. Window will not stay up

24 year old Norandex windows , number on the balance is 3640 , next to that looks like BSI -mb

Img_7386: is the whole channel balance img_7383 & img_7380: is the end of it img_7385: is the top only writing on the metal part is 30G AO length: 30in Width: 1/2in

Can you jelp identify and locate this Truth encasemrnt assemnly and hardware so I can order and gdt window crank functioning again

Hi there, I'm trying to figure out which specific channel balances to get to replace in 2 of windows. The windows and balances are the same sizes, the length of the channel is 27" (just measuring the metal part) and just in case you can't read the stamp it says "26-5 FQ5 CMC 1"

need wheel replacedment; unable to identify correct part (s)

Hi, I have block and tackle balances that are 28" in length and 1/2" in width, weight rating 2730. I can't identify the series because I don't see the right end components on your website. Can you help with this? I've already replaced these on my other windows but didn't realize the 3rd window was d ... (cont.)

Hi, I need help identifying these parts and being able to ultimately purchase them. I have around six windows in my house that need them replaced. I will also need the housing that goes with them.

Roller is 1 14" dia x 3/16" wide

Lower window crank assembly. I need both right hand and left hand part numbers, please

message