Viewing all customer Discussions for:

Door & Window

I went through your site and still can't identify this channel. It is for a non-tilt and the metal portion of the channel is exactly 30 inches long. Would appreciate your assistance as I need to order replacements. These are shot.

Hi, I have already sent a message before but did not get a response. I am looking for window channels for a Milgard window. It has the markings 29-9 JX CMC 7 as seen on one of the photos. Do you have this part or the equivalent? I need 2 of them. Thanks Samir

please see above - window numbers 2442 and 2432 - four balancers (cord providing) devices needed

I need to replace a bunch of window channel balances in my house. I have a bunch going bad at this point I am attempting to figure out end pieces as they are all identical and then I can start taking every window apart so I can figure out which ones need to be ordered. The current one I have pictur ... (cont.)

Hello, Do you have this type of snap in glazing? Thank you, Junior's Painting Roger

I live in St Louis and I'm going to my mother's in Phoenix to fix her house up so unfortunately the only thing I have is the one picture that I included and I'm hoping that you might know which crank handle I need to replace.

I tried to buy a Swisco lock mortise (40-198) for my new Andersen Storm door handle set. It is not the righ one. Do you have a better fit I should use?

Replacements needed for below please

I need help with finding left & right tilt latches for Atrium Windows.I have sent 3 photos to help identify them.

Please find the below specifications and attached pictures to assist me in purchasing new window channel balances. I will need 20 in all for 10 windows. The original hardware was stamped with UB28B , UB28C and 28D. I have measured and weighed all the windows which you will find below: 1. Qt ... (cont.)

its 3/4" wide and 3" long Please view the attached photos and any advisement would be great Please let me know if there is any additional information that is needed

There is no numbers or no name that I could see

american craftsman mis 190s(94?) vinyl sliding patio door. i need new rollers. can u help?5 ft

My Getty operators worked out well. It turns out that some replacement latches for the bottom windows are also needed. Can you help with these?

CAN I BUY THE PART IN THE PICTURE? stamped DR05-1510

Any color is fine anywhere to buy this part seperate? Mine says made in new zealand.

Pt # 39-107 5'4X1 1/8" plus cranks white 17 total

Have you any idea if one of your crank's will match the operator shown in my picture? It is a "truth" operator. I'm looking to replace one that broke. Thanks in advance.

I need to replace the balances on my window and I cannot exactly make out the stamp code on the originals. It is either a "2720" or a "2730." How exact do I have to be? Would either one work for my window, as long as I ensure the L x W x D measurements are a match? Thanks!

5/8" wide, top is 1 3/16" wide, length is 1 13/16"(top to bottom). We can't match it with anything on your website. Can you help? We are replacing the 1/2" channel balance that we purchased from your company a few years ago. The part number on the channel balance is 2965, what is your current ... (cont.)