Viewing all customer Discussions for:

Door & Window

Good Day I was just talking to PE Del Mar and they suggested you people may be able to help. I am looking for patio door rollers. Model D4001st Part #4131 Thanks in advance Mark

Product #S795-18 on the balance it is stamped 18-7-BSI do i ordered B or is it 7lbs which would be A i need to order 2 of them

Please help identify this part and your replacement part number. The arm is 5" long. As you can see, the gear is stripped. I would also Nike to replace the gasket and screws. Thanks!

Can you provide product specification/dimensions for your Slide Bolt Assembly Product Code: 91-179?

The window screens I currently use a plastic butterfly clip as pictured in the picture. They are pressed into the top and bottom channels. The one just installs the screen and tension on the two wings holds the screen in place. Problem is I am replacing these clips every few years as they become ... (cont.)

I'm looking for replacement roller wheel assemblies for a Weathershield sliding patio door. The manufacture date is 11/24/92. Do you have any listing for these parts? Thanks, Chuck

I have a commercial door with a hinge that RESEMBLES Swisco's 79-121. My pivot post has a 1/2" diameter. However, I think Swisco's is only 3/8". I actually need the piece above the bottom pivot. I just need something that can absorb the 1/2-inch post.

The stamp on my channel is 17S24. The channel length is 18".There are B.S.I. in small letters stamped perpendicular to the 17S24 and then in even smaller letters there is oc stamped running the same direction as the 17S24.Not sure what to order. Thanks.

Hello I have a window crank this is vitually identical to your #39-188. The zig-zag and overall dimensions are the same exept that on mine the arm measures 4 1/2 overall and 4" between the hole centers. Any assistance would be appreciated. Thank you

will Larson key corners work needs to be 1/4 inch

We are having a difficult time locating replacement slide rollers for 5 windows in our 4 Seasons sun room. I attached some photos and some dimensions.

Hi-you will be receiving a call from Bob, regarding these photos and replacement parts. Thanks, Kate

Windows were supplied installed on a 1990 RV (Park Model) orphaned by Sierra. After 26 years, sun has significantly dried out the part on the glass (not the insert) on a multitude of edges. I have inquired of numerous sources and been unable to identify a source for replacement of the glaze. If ... (cont.)

I have a bathroom window in CT, needs balancer. took photo of numbers as follows: B 75 31 675 would loke to know replacement part number. thanks bob

Please direct me to the correct replacement part. Metal part length is 27". Entire length 28" 2630 stamped on piece. Width of track is 5/8th.

Hi, do you have a replacement?

Please identify the replacement part number for a 1/2 wide by 27" long window channel balance with the following stamped on the back: 27 4 EN CALDWELL Thank you!

I am trying to locate a window opener for a Gorell window. They were purchased by Soft Lite and they gave me your info. Attached is the photo of what we need. Please let me know if you have any info for me.

Hello...thank you for taking the time to help me identify this glazing. There are no markings at all, and the house is approximately 23 years old. I have attached two pictures- one with the actual material and dimensions, and the other with where it was removed. I have about 7 windows I need to repl ... (cont.)

Need the rollers for Pozzi glass patio door . Heavy Door . Part number is 30622 , can't read properly 1980 patent 4194.266. Which rollers should I purchase . I need six of them Thank you Jay