Viewing all customer Discussions for:

Door & Window

Installed in 1999.Arm is 9”, but distance between screws is 4 and 7/16”.Thanks,Jane

Trying to match up this crank from back in 2001. Looks a lot like you 39-253LB except my white cover is affixed and does not come off. Original manufacturer was Truth Hardware #31876 stamped on bottom of one of the arms

Hello. Would this fit our K&K windows?Here are some photos. Marking says Truth Entry Gard.

Usually I can find out a balance just from experience but this one was odd/Unkown to me because I usually always see coil balances on double hungs but this one is on a single hung. They're marked 11L and 11R for left and right. I provided dimensions of the balance housing and how to balance mounts t ... (cont.)

7/8" wider from casement window. Looking for a match

I need to find replacement locks for sliding windows

I took a photo. I'm not sure what brand it is, but I need a window crank.

Coil balance is 3/4" wide and the sash weighs around 27 lbs. I found part S170-409 but I am not sure the weight limit. No stamp on balance.

Need Crank handle and Cover to Match the ones attached. Window Stamp is attached as well as close ups of Handle and Mechanical Cover.

Do you have this window handle turning spare part?

Channel balances in both windows are 28” long (metal portion only) and 29” long with plastic fittings. The bottom shoe on all channel balance fittings measures 1-3/32” depth. Both windows weigh 35 pounds. Window A Stamp: (Side 1) 2790 BSI PN 30 and (Side 2) 2790 BSI JN 30. Window B ... (cont.)

This client looking for this type of rollers and stoppers

need help identifying this pivot bar.

I need 2 sets of these

Hello I'm looking for this operator on the left and right side, The long arm measures 5 3/8 and the short measuring it from the center measures 4½, waiting for your prompt response. Thanks

I have a casement window with truth parts, probably 30+ years old. Original to the window. The window cranks open but the crank doesn't work at closing. There are multiple part #s: 6993, 20810A, 31538A on the 3 parts. See photo. I think the gearing has worn and I need to replace those pieces N ... (cont.)

Need to this pin. I don't know manufacture of my windows It measures approximately 2 7/8" by1/2"and 7/8"tall

I need a latch just like in the photo. I think the dimensions are the following: 2 x 1 x 5/16 or there abouts. The latch is needed for a set of older windows. I bought latches from from Amazon that were similar but not exact copies of the latc, but they did not work. Lowes and Home Depot only had la ... (cont.)

i am looking for a patio door handle , for patio sliding glass door (all parts ) Thank youIrene

Window balance and pin also latch's needed for vynil single hung windows