Viewing all customer Discussions for:

Door & Window

Hi, my 70s era crank out is broken. Please confirm that I need to replace the mechanism. It's right side crank. Do I need 5 1/4"? Let me know if you need anything else.Joy

I need this part with a 14" arm. I see it with a 9" arm.

Hello. I am looking for help with replacing a broken latch set for an olderCole Sewell storm door. The exterior is an antique brass finish and theinterior is a white finish. I have attached four photos for your reference.Please let me know if you have some replacement recommendations/options. ... (cont.)

I need about 20 pivot Shoes, Retainers and Various length of spring Balances.

Hello and thank you in advance for helping with our needed window rollers . Should we send a picture of the existing roller ? We can remove it and take measurements .

Good afternoon,I am looking to replace my bathroom window lock. Attached are the parts. Can you confirm this is a SWISCO? Thanks,Josh

Good Afternoon, I am looking for a window clip that is 2 5/8" in length and 3/4" in width. I have found some similar latches, but they seem to be too long for the one I need. I have attached a picture of the latch/clip that we are looking to replace. Please get back to us as soon as possible. ... (cont.)

Width is 1/2 ", length of the channel is 26 3/4 ". The stamp(picture included) says 26 4 B.S.I. OT. I need 2 of these for one non-tilt window, but have additional for other window sizes throughout the house. All installed at the same time ~2013.

Hi, I have a problem with my Viking window. It has broken/missing sliding bolts on both sides that allow the window to just fall open. Can I replace the parts and what are they? Can you tell what it's supposed to be from the photos? And if so, do you sell them?

Looking to replace the brown window glazing in the courtyard of my elderly clients home. Can you identify the appropriate replacement? Thank you

Good afternoon, I'm trying to find a replacement finger latch, as well as 2 balances and pivots but im havimg some trouble locating the right ones. Any help would be greatly appreciated.

please help identify my balances

looking for a window closuer device like this?

Current (Jordan) windows are terrible to open and close, hoping new sliders will help. These appear to match options on this site but want to get the right ones. The metal part of each piece is 28"

This is the side part that help the window go up and down . Thank you

We are looking to replace this door handle and are not able to find it at any stores

I had a coil Balance break on this Simonton vinyl window. Looking for replacement parks

Hi, I have a crank out window that was made by a Company called Outlook. We built the house in 2001. The top drip edge of the window has become brittle and chipped off. It appears to be an extruded part. Please see attached pics. Do you sell a replacement part? Also, it appears that the sl ... (cont.)

Looking for these parts. Thank you.

Any guess as to what part can replace this broken spring slider (not even sure that's what you call it)? The slider fits in a channel that is 1 3/4 inch wide, 1/2 inch deep, and the window sash overall is just over 22 inches high. I do not see any cutout notch in the channel to pull that slider out ... (cont.)