Viewing all customer Discussions for:

Door & Window

I need two plastic strips that came with the casement windows originally. I believe this makes them weather tight.Caradco side windows 916 has big middle window it is bay type window Also would 39-505 entrygaurd be used on this type of winow? Thank you

do you have a hinges for windows not tilt

I ordered 2 of part# 26-336. Can you provide brief instructions as to how to insert these on the sides of the window and place the window back on the frame? I was having difficulty placing the tilt window back on the frame after inserting the pivot bars on each side

do you have plastic track for rollors

My metal sliding door(s)are ~25 years old...the roller assembly looks like the 81-009 Miller but I cannot be sure for I cannot remove the assembly. I did successfully remove the roller (wheel) itself and found that the pin (shaft) appears to be broken. Is there any way to confirm the manufacturer? H ... (cont.)

Do the 70-017 clips come with the screws

When i order S374-17 balances, I have been asked to choose a option 1610, 1620, 1630 1640, etc, what that for? if i do not take options, i can't contiuse to order.

how far are the holes from the 9/16 end of the 26-272?. I havea bar that is the same size, with holes that are 1" and 2" from the end.

Not necessarily. You should remove your old sash guide and compare the measurements to the measurements in the 18-166 product image to be sure that it will fit.

The 32-308 door stop is only available with a brass plated spring a white tip.

By any chance is there a similar part to 55-172 available in brown(ish)? Thanks Matt

do you have a photo of the 20-007 with the antique brass finish?

Can these 4" extensions (39-157) be used together to create an 8" or 12" extension? I have a Kitchen boxed bay casement window that is hard to reach from the sink and need an extra 8-12" reach to operate the window. Thanks Steve

In looking at the dimensional info for the 95-218, it appears this may fit a 5/16 x 3/4 frame. Is this correct?

I need a snap-on crank, NO set screw. Gear spline diameter is either 3/8 or 11/32, not sure which.Color is white. Don't know the window brand.Prefer folding crank.

Are the 20-007 lifts brass plated steel stampings?

Would the 81-098 roller also fit the Pella 806CS patio doors (circa 1985-1987)? That's the only "number" on the door/frame I can find. If not, is there another part that would fit it? I didn't want to take the door out of the frame until I knew for sure. The roller is really messed up at this po ... (cont.)

Do the 38-001 screws come with the locking handle?

Are the 84-066 Rollers supplied with stainless steel screws? Regards, Bernd