Viewing all customer Discussions for:

Door & Window

2.5" approx in length

I'm looking for replacement parts for these plastic sliding window screen wedge clips.

Unknown brand or model, installed 7 years ago, purchased at Lowe's or The Home Depot. Pin seems to have separated from assembly, so will not raise or lower into hole in door frame.

This vinyl glazing holds the glass in a storm door. Two 30 inch pieces were throw away when the glass was broken. I have been to several window and glass companies and a glazing supplier and no one has this particular product. On the glazing it says "With print towards you, Insert this end. Do not t ... (cont.)

Could you please let me know which operator I can use to replace my existing one? Will I be able to reuse my existing cover and handle?

Hello, in need of replacement window channel balance because one broke again. the Stamp on the Channel balance is ( 25 4 FV CMC 2) please advise thank you Sue

Thank you!

Do you have a replacement for a V-shaped Gerkin storm door sweep? 1/8" wide x 1/2" tall. Photos attached.

Where can I find this replacement? Do I need to replace the whole mechanism? Thanks, Tom

Hi, It looks like I have double spring (very busted) on the larger window (40x30 pane) and single springs on the smaller windows. Do these come in different widths/sizes or are they standard?

I need 8 of these but not sure where to start

Interlock world pats 12C-1S23 EN Mid sill mechanism in white right side hinge stuck with parts separated. Can't open or close window properly.

I have 2 casement windows that are different sizes. I do not know the manufacturer. Sticker on window seal says mfr: mgm-1. Validator. Series 4700 casement. I only took a picture the decal in the kitchen. The window in the bedroom is larger. The window in the kitchen with the decal picture seems to ... (cont.)

I can't seem to find the parts for the system that has a center locking system. All of the ones I've found have offset locking ports.

Hello, I am needing to purchase new channel balancers. This home was built in the late 1980's. The only marking I am able to see is 2810, on the channel. Can you please identify the correct part for me? Thanks

Looking for a part that could replace a few of these which are no longer working, plus how to replace? Thanks

I have 15 windows that need these balancers. I am not sure how many of each that I would be in need of. Please do not hesitate to contact, thanks.

Cannot find these online.

Numbers on arm= 1 361 485 R, 1 361 482 HGR

The depth of the lock set is 1 3/4". I need the lockset, handle for 1 door and dummy set for the door next to it.