Viewing all customer Discussions for:

Door & Window

The part I'm looking for is supposed to keep the half screen, half storm window from sliding down. It has a plastic post on the end (which has broken off on many windows) that goes into a hole on the frame of the window to hold it up.

I need crank operator from the photos attached

It had a flat bb wheel.

Mid 90's Milgards- metal is 33' and 1/2' wide if we are sure of the ID....please send 2!

I need new spring balancers for a window restoration.Dont know the weight of window sashes. Single pane glass, sashes are upper 24" x 27 1/2" , lower 23" x 27 1/2 " wide

I need rollers and a new track.

This piece is in all my windows holding my screen in. I can not find a replacement or know what they are called!

Need to replace balance on a non tilt window.

Hi - could you advise the correct balance and end pieces to match this? Thank you!

Can you please advise one what would the a pro type of this so I could order? Thank you in advance!

I have a Del Mar Eng roller with a pat. # 3670357. It has a narrow tab and most of the off the shelf ones are too wide. The roller is nylon and I believe 1 1/4". What would your replacement part be?

Our handle broke. Do you have replacement?

27" long (not including plastic end), says 86 26-4 CMC 2, 9/16 wide channel

Hi, Please let me know if you have any of these types of window parts? If not, do you know where to find them? I have a number of windows that are rusted-out that I would like to replace. Thank you! Best, Keith

This is screwed to the window and needs to be replaced

This is 9/16 wide, 21" long (not including plastic tips). it says 180 on the plastic part on the bottom and 20-4 AP5 CMC 77 is printed on the channel.

Hello, I have bought from you before but I never know sizes.....It's a channel balance with the following printed on it " 26 3 GW CMC 7 ". I measured the metal piece and it is 27 inches (28 inches if we include the plastic pieces on both ends).

I'm looking for a pivot bar for a sliding window. The pivot bar sits in what looks like a miniature car with 4 brass wheels that is part of the mechanism to allow the window to slide. Flipping the pivot bar up allows the window to be taken out. I don't see any name on the window. ... (cont.)

The photo is for our right side sliding glass door lock/latch. Our left side sliding glass door needs the same parts and the door jam parts the connect to. Is this your brand? I saw an A W logo, can you assist me?

Parco window circa 1996