Viewing all customer Discussions for:

Closet

Hi , my name is Nicolae , I will like to know if you have the hardware for the bifold closet doors in our rental building as showed in the pictures. The first picture is shows the small parts of the hardware assembly for upper tract , holding the door by means of a pivot pin. I saw the pivot pin th ... (cont.)

One of the mirrored doors on my closet is cracked. It is a monarch mirrored sliding door.

I'm looking for two of these parts, thank you.

Custom Door & Mirror, Inc. mirrored bifold door 24 X 80 Looking to replace missing handle.

Bifold mirrored doors installed in 1984. The nylon slide/pivot in the top rail contains a slot into which the pin supporting the end of the door clips / hangs. Rail width is about 3/4". The slot on the left in the picture below of the slide/pivot has worn over time such that it no longer holds the p ... (cont.)

Here just need the rollers wheels that's all

I sure do hope you can help me find a replacement roller for my customer's pocket door This part is the only one I have. He says the other one is completely gone. Rollers are 5/16" thick, 1-5/16" in diameter.

I am looking for hardware that matches the photos for a mirrored closet door. The hardware is at the top of the door. I am in need of at least 2. Any help would be great.

Need 120 inch replacement track for mirrored 4 doors closet.

I have a few Bifold doors in a house built in the 1980's. I am missing a top pivot bracket on one of them following a flood. The similar bracket on another door has the part number ACME 30-2612-1. Would a Stanley BF50-11 fit this application? If not what would? Regards Jonathon

For Leigh Full-Vu metal Bi-fold doors (see label photo), the pins & nylon parts are either missing or not holding due to wear, bending, etc. The pivot pins at the fixed ends appear to be fine. Your parts specifically say TOP. My question is whether the bottom pin assemblies that slide are identical ... (cont.)

I need this to go to the corner block. Can you please tell me which

I have two brackets on the rearmost door of a mirrored closet pair. One bracket has broken and it appears that the rectangular plastic slide that was in the track has broken. The part with this number on your website has a plastic wheel attached to the holder and I do have two of those on the fron ... (cont.)

This is a plastic piece that slides over a 11/16" metal track. They were made out of plastic and probably installled 60 years ago. I need eight of them. Can you help identify?

I would like to purchase parts for the RAMTRACK sliding wardrobe Ten of each  units number 10124                       units number 10122

Keith. Thank you

I need the edge/pull for monarch sliding mirror glass door and wheel Monarch AFG-2-2-03-90

Old heavy mirror faced sliding closet doors. This is the hardware that goes on four corners and into track.

May I please have detailed installation/removal instructions for this part?

these are at the bottom of my sliding mirror bedroom doors, but they are broken off