Viewing all customer Discussions for:

Closet

I sure do hope you can help me find a replacement roller for my customer's pocket door This part is the only one I have. He says the other one is completely gone. Rollers are 5/16" thick, 1-5/16" in diameter.

I am looking for hardware that matches the photos for a mirrored closet door. The hardware is at the top of the door. I am in need of at least 2. Any help would be great.

Need 120 inch replacement track for mirrored 4 doors closet.

I have a few Bifold doors in a house built in the 1980's. I am missing a top pivot bracket on one of them following a flood. The similar bracket on another door has the part number ACME 30-2612-1. Would a Stanley BF50-11 fit this application? If not what would? Regards Jonathon

For Leigh Full-Vu metal Bi-fold doors (see label photo), the pins & nylon parts are either missing or not holding due to wear, bending, etc. The pivot pins at the fixed ends appear to be fine. Your parts specifically say TOP. My question is whether the bottom pin assemblies that slide are identical ... (cont.)

I need this to go to the corner block. Can you please tell me which

I have two brackets on the rearmost door of a mirrored closet pair. One bracket has broken and it appears that the rectangular plastic slide that was in the track has broken. The part with this number on your website has a plastic wheel attached to the holder and I do have two of those on the fron ... (cont.)

This is a plastic piece that slides over a 11/16" metal track. They were made out of plastic and probably installled 60 years ago. I need eight of them. Can you help identify?

I would like to purchase parts for the RAMTRACK sliding wardrobe Ten of each  units number 10124                       units number 10122

Keith. Thank you

I need the edge/pull for monarch sliding mirror glass door and wheel Monarch AFG-2-2-03-90

Old heavy mirror faced sliding closet doors. This is the hardware that goes on four corners and into track.

May I please have detailed installation/removal instructions for this part?

these are at the bottom of my sliding mirror bedroom doors, but they are broken off

How do I know to use 23-070 or 23-086? They look the same. One has ball bearings and one does not. Is one better than other? Would either be compatible with my mirror doors that currently have COX 21-717 21-767?

Hello! I am in need of a replacement track for my sliding glass doors and, as the fellow before me, there isn't a code on the door. Here are my pics in hopes you can help. Thank you, Shelley

Hi I need four of these rollers for my sliding closet door(mirror). Please let me know if you them. I need 4 . Thank you very much Cyrus

We have 3 bi fold doors that need repair and one double bifold door that needs repair.They all need new stationary pins, plus the pins with the springs. the double bifold door keeps opening off the track, not sure if it piece that runs across the track is too short.Do we need two pins for each stati ... (cont.)

I'm looking for a sliding screen door track top u channel. It is 72 inches long by 3/4 inches wide. It is white, but I can paint it if it isn't white.

I have a Stanley Sliding Mirror closet door which needs replacement of one of the rollers. I don't have a part number but have uploaded photos of the roller and a label from the door which may have the model number of the door on it.