Viewing all customer Discussions for:

Closet

Hi! I have US Plywood metal closet doors throughout our house. We found a set in the rafters and would like to install them back in one of the bedrooms. I have a couple questions, I have the 21-154 (pivot rod clamps) in my cart but I couldn't find the little metal cover parts (see pictures) that are ... (cont.)

Did you have some partshikmat Subject: 3/4 roller 1/2"offset door

Looks like 23-240 may be a close enuf match, what do you think? Its for a wheels support doors on the bottom set up

Hello, My name is Peter and I am looking for the two of track as I uploaded pictures. I need 60'' and 72'' long. Please recommend me which products are proper. Thanks. Peter

Bought the lower track. Has cut-out for 7 screws, but none included in shipment. Will probably need to go into concrete (1st floor apartment). Recommendations on what to use?

this plastic piece fits on top of the closet sliding glass door.

Hi folks - Older home 1961 in California with heavy solid wood bifolds -- pin and rail. Rail appears to be metal insert. REALLY don't want to replace as they are quality doors but the rail has 'disappeared' and worn out in several places, so want to lovingly refurbish. Found a handyman to do the w ... (cont.)

I need the winged tabs as shown in pic. They seem to keep the pin in the hole.

Is there connection/coupler pieces available? Additionally, what is the best way to cut the pieces to fit? Tin snips?

Hello, I'm trying to identify which bifold track I need to purchase. Ady advice is much appreciated. Thanks

does the star piece of the unit allow the door to be adjusted after it is installed?

Followup to previous email. I am in need of a replacement roller for my closet door

For 1-1/2 inch solid wood bifold doors

I need 8 of these pins with the springs

Looking for bifold closet door with plastic inserts.the label inside give this address Roseville, Michigan it says to ask for doo (D)

I need to replace one that is broken. Your 23-044 looks like it may fit. Can you confirm? How do u remove it without breaking frame?

Wheel supporting our sliding glass door system has failed. We have been told by a glass company these parts are no longer available. We are hopeful after you have seen these photos a replacement can be recommended. Thank you.

Where can I purchase

(Sorry-photo is upside down). No markings. Screws into top of door & plastic goes in track. Spring inside plastic. Approximate measurements of plastic piece: .623 across; .571 up & down; .435 across stem

Can you please advise on a replacement part for this ball bearing roller?--Thank YouMark