Viewing all customer Discussions for:

Closet

Hi. What top and bottom track do you recommend? I have 4 doors of 30" width.

I need to replace these little plastic parts. After time, they wear out and do not hold the door pin in place. It's an old sliding door. Circa 1975. If you don't have these, can you recommend a replacement assembly? I'd like to avoid replacing the complete door. Thank you.

Not sure the brand name of doors and model number.

Looking for those two pieces to replace on an existing door. As I've noticed, other's have the same address to address issues, but no company name and it was pre-internet, so no web address. BUT, BTW: When I search online for "P.O. Box AC, City of Industry"... your site came up. So, do you have ... (cont.)

Installation of roller

These are floor-to-ceiling sliding mirrored closet doors. It appears the prior owner used different types rollers. The only number I could find was 50121 on one of the working rollers. I just need 2 bottom rollers that will work on these type of doors. I sincerely hope you can help me. Phil page ... (cont.)

I have old metal bi fold doors in my house and they no longer stay completely shut, there slightly bow out. I was told I need a spring in the top track to create tension to keep the door closed. However the part that is in the doors now, appears to have no spring and is just a rubber bumper. I pulle ... (cont.)

Each panel on the door is 15 3/4 inch and the door frame is 32 inches wide. Will this kit ( 23-504 : 3' Bifold Door Track and Hardware Kit, 2 Panel) work for this size of bifold door?

Need replacement

Looking for 2 rollers in picture old Stanley mirror closet door 2003

Hello, I see on your website that you have similar parts to this one, but I am unable to find the exact part. Please let me know if you carry this. Thank you

on the lower door sliding mechanism for the mirror door piece of plastic broke off of this roller I want to know if it's possible to get a replacement or replace the whole item

Hello, I need to replace these old rollers with new ones. I seen some on your site that were very similar. But the bracket was a quarter of an inch wide. I don't think it'll make a difference but I am not sure

4 doors that are 18" each for 6' total closet opening I need the plastic tips on the pins (note that the threaded pin has a smaller dia than the other 3 pins where the tip is installed). I also need the track for the top and the mounting brackets (or track) for the bottom of the door and any addit ... (cont.)

I need 2 of this part

bottom guiding pin for metal mirror bifold trailing door that fits into plastic corner block. Diameter of plastic pin holder is standard 3/8". Top of pin is all metal

I need to replace the bottom track for a Monarch mirror closet sliding door. The track is 3.25" wide and 0.5" high and 71.5" long. Thank you for any help.

I'm looking for a screw adjustable fixture that takes the place of the spring loaded one I have due to the nature of my project

I need 12 of them.

Last time the photos did not attach. I am looking for Replacement Bottom Rollers for Sliding Mirrored Closet doors. Exusting rollers are ACME 4C12. Thanks Ashu