Viewing all customer Discussions for:

Closet

can you give me the specific measurements of these two items especially the plastic roller?

Can u please tell me where I can find a replacement for this Thx

I've been unable to find any part #'s or markings on the hardware. The thickness of the roller may be 5/16-3/8". If you need more information about this part, I'll need to revisit the location the next time I'm in that neighborhood when I can catch the owners home. Thanks for your attention. Y ... (cont.)

Do you recognize this piece of hardware? My son recently purchased a condo and one of the closet doors has a piece of hardware missing. We are hoping to obtain another to fix his door.

Can I get the bottom metal guide for the sliding doors? I cannot reed the numbers on the stickers on the back of the doors but it looks like 90209061.

Do you have this part?

My son has these glass mirror doors on his closet in his room, and I would like to remove them. While there are many people asking this question on this site I still have yet to find an answer that yields any results. I don't want to break the mirror and when I try to lift and tilt the doors nothing ... (cont.)

I am missing the pin that holds the door to the track on the closing side not the pivot side. Please help me identify needed part. Thank you, Patrice

I need to replace 2 acme 30-1001 bypass rollers on two different projects,I see that your 23-189 will work.Do I need to remove track to install or can I just snap it on?

6 foot track is damaged on one end. do you have replacement track?

Measurement in picture: 1 1/4" wheel diameter. Mounted on a 5"x 27/32" steel plate that is about 3/32" thick. Holes are 5/16" from edges and with the exception of the one marked at 1 5/16". Wheel is center grooved and 5/16" wide. Bolt head has what appears to be 307A on top and L on bottom, 1 5/ ... (cont.)

My appartment complex has about 300 leigh doors, all it says on the doors is quality control approval number 559245 I need hardware kits for the pins and the bushings that slide in the rails both top and bottom

Please help me find the correct door wheel replacement. Thank you. 4212

I have Leigh full vu bifold doors model S907213 (5' door) and S995806 (3' door). The track and nylon guide and spring are worn out. Can you recommend the complete replacement set for these doors that were installed in 1972. I have 3' and 5' doors. I have about 60 sets of doors that are wearing out ... (cont.)

Hi there, I'm helping my parents fix the bottom track of their sliding mirror doors. The track is 60 inches long and has two mirrors (one in the front and one in the back). I only have the two enclosed photos and know that the width of the track is 60 inches. Please let me know what replacement ... (cont.)

This part slides onto the bottom or the closet door. There are 2 rollers on each door. D/M 3137028 A/S 3097401

I need to replace the guides for my closet doors. It's similar to the ones I see online, but not exactly the same. Thanks.

We are trying to use the pocket doors in a house that we just bought, but all the roller hardware has been removed from the doors. The part that is inside the wall is still there, but we need 7/8 in grooved wheels to finish this job. Do you sell these. I have been checking the site, but don ... (cont.)

I a looking for a replacement for the attached pictured part. Notice that it the door frame rests on the assembly. Thank you.

I need help at getting the right size top and bottom pivots, for my bifold doors. I would also like to get more brackets for the pivots but don't know the right size. And while I'm at it I'm going to get the glide pins replaced.