Viewing all customer Discussions for:

Drawer & Cabinet

Hello, I need to replace the drawer back plate is broken. The rails are 23" long. I have not been able to find replacement plates in the city. So I will buy extras once I find them. Thanks for your help.

I am looking to replace several old Ajax kitchen cabinet hinges that have a 3/8" inset and a 1/4" overlay in antique Bronze. The hinges are about 40 years old and have either 597 51 or 597 51 on the back side of the hinge. 3/8" overlay hinges cause the old screw holes to be exposed and will not wo ... (cont.)

It is inside cabinet behind the drawer. It's about 3in tall. I operates along the same principles as the magnetic pop-up door closer/catch. When you push the drawer in it loads it then when you push the drawer again it pops out and pushes the drawer open enough to grab it and open it, but you alread ... (cont.)

Hello - I dropped a heavy item on the drawer and bent the face frame undermount brackets of the drawer. The drawer undermount slide is 19 3/4" and the bracket that attaches to the back cabinet is 23 1/8". Do you have replacement brackets and back wall mount? Saw an answer on your website that sai ... (cont.)

The side of the stop cracked off and I'm trying to replace it .instead of screws it plug into the back wall

No marks. Measures 2.5" wide 1.75 tall and3/8 deep

I am searching for a replacement knob for my Pulaski chest. Pulaski Accent Chest 704286 I have included the other hardware used to compliment the drawer pull. Thanks in advance. Angela.

We'd like to keep an old family dresser to use for new baby arriving but the Center metal guide/slide or stop is missing from underneath all but one drawer. It appears they broke off at the front and back ends of these drawers. I've searched for these metal 'things' and can't find and plastic guid ... (cont.)

Slot is 15/16" wide and 1/8" height

Thomasville Furniture pull. It has a number 2 on the back.

Metal drawer sliding rails are made by Hafele but bracket says ADAR. House is 6 yrs old. Soft close kitchen drawers. Rails are just under 1 inch that go into bracket. Any help is appreciated.

The side rails are metal bars with holes spaced 10 inches apart. Attached are photos of one of the slides and one of the 8 fasteners which has a rounded head that appears to be about 1/16 inch tall when installed. What do you think? Is this enough information? Thanks, Christina

Having hard time finding one for my drawer. It isn't fixable. Sent pictures if any help can be provided it would be greatly appreciated Thanks

Can you assist in helping me purchase the correct guide. Please see attached photos. Thank you

A piece on inside broke off. So door wont close. Do you have tbis tupe of hinge?

Any help ordering the correct part is appreciated

Our home is 13 years old, and we do not know the manufacturer of our kitchen cabinets. The top drawer that contains our silverware is not usable due to the back pieces of the drawer rail guides breaking, and the top of the piece that holds the drawer down has broken off.. The inside drawer dimensi ... (cont.)

Any suggestions on replacing arrow metal shed plastic slides with drawer rollers/brackets from swisco?

How wide is the opening for the rail to slip into?

The photos are of the left side bracket. I need the right side as well. The bracket is 1 1/4 inch x 2 1/4 inch The channel is 1 inch in width