Viewing all customer Discussions for:

Drawer & Cabinet

The white plastic piece at the center of th door hinges broke off and the doors no longer self close and stay closed. I have attached two photos. The first photo of the right hand door shows the hinge with the broken white piece and the second photo shows a good hinge. The part number on the back ... (cont.)

This plastic bracket is broken on two of my kitchen cabinets, causing the drawers to fall of the tracks and downward. I'd like to replace these before reinstalling a new brackets style. The plastic piece snaps into this black bracket behind the back of the drawer.

Can you identify my hardware which is about 40 years old? I seek two kits(two per kit)

I need both sides times 2 for the end supports for the pictured rail. Rail has KV and a smaller CR stamped on it.

Kenlin is the name on the back of the part. I goes to a dresser and the part number that slides over it is 32-081

This part comes from a kitchen drawer. This (and a similar, but mirrored set up on the right side) was mounted onto the bottom of the kitchen drawer, and the drawer slide goes into it and gets captured by the plastic parts (the lever can then be used to release the slide). At this point, both the ... (cont.)

Need help identifying the type of drawer stop shown here.

This part has a patent number of 2857233 stamped on it. It was for a dresser purchased new in 1983. I think it is around 3/8' thick at widest part. My measurements are made with an old micrometer and maybe off by some percentage. It is shaped like part # 32-031, but don't know if that is the correct ... (cont.)

Late 80's cabinets have these plastic pieces that sliding drawer tracks go into. They are starting to break. Do you have replacement pieces? Got the broken piece(s) out, 301515 is the number stamped on the plastic piece.

3 pics show, the first 2 show the piece I need, the 3rd pic is the broken bracket that I'm needing to replace my drawer back bracket

I'm trying to replace and or repair circa 1995 C Grass under mount drawer guides. 22 inches long.ThanksFran

Drawer hardware needed for circa 1980s oak chest of drawers from the Windjammer collection by Young-Hinkle.

Searching for rear brackets for drawer slides

On underside of base: 60.1961 L

how much will the drawer open on a 12 inch slider the one I have now only opens 4 inches I can't see in the drawer

I'm. Looking for new parts

This stopper from a rollout drawer needs to be replaced and I cannot find it anyway. The house is a Shea home, built about 3-4 years ago,

Can you tell me the length of 32-018, I am looking for a bracket that is 3" long

do you have this part

Two of the brackets from my kitchen drawers are broken. I would like to replace the brackets. Do you still have this bracket? If so what do I need to order?