Viewing all customer Discussions for:

Drawer & Cabinet

This hinge is from a Robinson Hutch door made here in Wilson Michigan bought in th mid 90's. They are self closing and all need to be replaced. The plastic spring holder has broke on them. Not sure the style or measurements. including photo's. No help at all from the company that makes the hutch. ... (cont.)

Hello: The above is off a bathroom cabinet, the left hand side. Markings show "643." I cannot find a replacement bracket anywhere. Thank you in advance for your assistance.

For a dresser drawer slider

Back to front 3 5/8" Opening 1 1/4" outside 1 1/8" inside x 5 /8" outside 3/8" inside

Hello, I'm looking for a replacement cabinet door hinge. I believe this is called a bi-fold hinge. When closed, the cabinet door is at 90 degree. The "installed above" photo shows how the door opens. I think this is actually made of a few parts that go together. I only see the name Blum on the lar ... (cont.)

This holds the drawer glide in the back of the cupboard

Which rear socket fits the 32-061 drawer slide?

Looking for several pairs of this bracket.

Hi, I am looking for replacement pull handles for my Vaughan Bassett dresser. Below is an image of the handle. The size is 3 inches from hole to hole. Thank you for any help.

Hi, I'm looking for this part- see attached Do you know the part number ? Can I buy it directly from you ? image1.jpeg Thank you, Eli

Our cabinet drawer had a part break. There is a slider rail in the middle of the bottom of the drawer. The part that broke was at the back of the rail. It kept the drawer from getting off center as the drawer closed. Thanks

This is a plastic drawer slide guide that goes in the back of the cabinet. The metal slide goes in the plastic piece. I do not have the name of the company that installed the cabinets nor do I have the name of the cabinet as these were installed when the house was built. Kindly let me know if you pr ... (cont.)

Do you have a hinge in Nickle finish to replace this one? The offsets are 3/8" I think I am looking for a "partial wrap" hinge. The partial wrap I found on your websites does not match either. From the markings in the photo I set can you identify the manufacturer of my hinge? Thanks. ... (cont.)

Please help it is for a biFold door. I ordered 32-346 but this part looks like the cabinet to door hinge. I need the door to door piece.

This is located under the front of my drawer. The drawer sits on the slide and clicks into place. There is a small hook on the end of the orange lever that broke off on BOTH left and right side

This piece is for the left rear mount for a kitchen drawer. The cabinets are identified Marsh Furniture Co. Thank you for your assistance.

No markings

Inside under hooks measure 25/32" wide ---- between hooks is 7/16" and depth under hook is 5/16". overall width is 2" ---- height is 1" and 23/32".

We have Thomasville cabinets & the draws dont fully close. Can we purchase new draw softeners. Looks likea plastic clip with a piston.Thanks,Bill

All markings in pics