Viewing all customer Discussions for:

Drawer & Cabinet

Our cabinet drawer had a part break. There is a slider rail in the middle of the bottom of the drawer. The part that broke was at the back of the rail. It kept the drawer from getting off center as the drawer closed. Thanks

This is a plastic drawer slide guide that goes in the back of the cabinet. The metal slide goes in the plastic piece. I do not have the name of the company that installed the cabinets nor do I have the name of the cabinet as these were installed when the house was built. Kindly let me know if you pr ... (cont.)

Do you have a hinge in Nickle finish to replace this one? The offsets are 3/8" I think I am looking for a "partial wrap" hinge. The partial wrap I found on your websites does not match either. From the markings in the photo I set can you identify the manufacturer of my hinge? Thanks. ... (cont.)

Please help it is for a biFold door. I ordered 32-346 but this part looks like the cabinet to door hinge. I need the door to door piece.

This is located under the front of my drawer. The drawer sits on the slide and clicks into place. There is a small hook on the end of the orange lever that broke off on BOTH left and right side

This piece is for the left rear mount for a kitchen drawer. The cabinets are identified Marsh Furniture Co. Thank you for your assistance.

No markings

Inside under hooks measure 25/32" wide ---- between hooks is 7/16" and depth under hook is 5/16". overall width is 2" ---- height is 1" and 23/32".

We have Thomasville cabinets & the draws dont fully close. Can we purchase new draw softeners. Looks likea plastic clip with a piston.Thanks,Bill

All markings in pics

Looking for corner brackets underneath drawer in front. One on each corner side to hold drawer from falling out of guides for Masco Quality Cabinet product base from October 2016 in our reception area. Please advise if these are still available.

to whom it may concern, I need 2 slide drawers no: 3600 101 009, is it still available?

I could not find any markings on this part. I need a replacement for it, as the one in the photo is broken. It is a plastic rear bracket for a kitchen drawer slide. I would be grateful for any help in locating a replacement for this part. Thank you!

This is a handle from a thonasville dresser approx 7-8 years old. I can find the model number of the dresser if that will help.

This is a picture of a good latch. I took the drawer out and turned it over. This latch is on the left side. I need a matching latch that mounts on the right side. Remember the drawer is turned over. (Upside down) The cabinets are only 31/2 years old. Thanks for your help Steve

If you can zoom in on tab pat# and trademark on part

I can find this product but need a larger size. The opening measures 1 and 3/10 inches. And it is 2 and 7/10 long. Drawer slides are stamped with CR but I can't figure out which manufacturers that melons to.

I can't seem to find the glass support brackets for my cario cabinet

Part #198.660-01.22 This part # is just one piece of the mechanism.

Hi, I'm hoping you can take a moment to help me out. I'm desperate to find the roller parts for a 40 year old, Geneva Kitchens (now out of business) cabinet. The cabinet has two sliding glass door with metal frames that both slide left or right on a track at the top of the doors. The rollers are ... (cont.)